AEG 6281 I Leak Prevention System, Electrical connection, Appliance is automatically pumped out

Page 37

Installation and Connection Instructions

 

Leak Prevention System

 

For protection from damage due to water leaks, the dishwasher is

 

equipped with a leak prevention system, the AQUA CONTROL SYSTEM.

 

In the event of a fault, the safety valve immediately interrupts the sup-

 

ply of water to the appliance and the drain pump switches on. By this

 

means water can neither escape nor overflow. The remaining water in

 

the appliance is automatically pumped out.

1

The AQUA CONTROL SYSTEM also works when the appliance is switched

 

off – the appliance must however not be disconnected from the mains.

Electrical connection

1

In compliance with electric company technical requirements for mains

 

connections, hard-wired connections to the mains may only be made

by approved electri-cians.

When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local elec- tricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.

Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a change-over switch, the additional instructions on the change-over diagram in the mains connector box must be observed.

Prior to connecting ensure that the mains voltage and current rating at the site of installation match the nominal voltage and current rating given on the rating plate. The required fuse protection is also to be found on the rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

If the appliance is hard-wired to the mains supply, then it must be safely isolated from the mains within the electrical installation with switches intended to ensure all-pole(N,L1)disconnection, shall be directly connected to the supply terminals and shall have a contact separation (fuses, cut outs, current trips or similar) of at least 3mm in each pole.

37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Ökofavorit 6281 Dear customer Tips on using the appliancePlease read these user instructions carefully Use of the appliance are marked with a clover leafContents Installation and Connection Instructions Installation, connection and initial use Safety instructionsChild Safety Intended use General safetyDisposing of the Packaging Material DisposalDisposal of old appliances POM For polyoxymethylene, e.g. plastic clipsEconomical and Ecological Dishwashing Appliance Features and Control Panel Control panel Prior to using for the first timeAdjust Adjust the water softenerSalt Hardness range of the water in your areaFill with special salt Filling with Special Salt for the Water SoftenerUse special salt Open the door, remove the lower Rack Turning it anticlockwiseThat you glasses are clear Filling with Rinse AidWould damage the appliance Fill with rinse aidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading cutlery and dishesBefore loading the dishes, you should BaseLoading Cutlery Load large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans Large PlatesLoading Cups, Glasses and Coffee Services Lowering the Upper Rack Adjusting the Height of the Upper RackRaising the Upper Rack Maximum Height of the DishesUse only dishwasher detergent Filling with DetergentFill with Detergent Tions given on the detergent packagingBio Wash Programmes and Concentrated Detergents Selecting the Wash Programme Programme Table Start the wash programme Changing/Interrupting/CancellingWash Programme Changing the wash programmeCancelling the wash programme Setting or Changing the Start Delay TimerSetting the start delay timer Changing the start delayLoad Sensing Sensor Logic Switching Off the DishwasherEmptying the Dishwasher Cleaning the Filter Care and CleaningPut the flat filter back in the base Washing compartment What to do, whenMalfunction Possible Cause Remedy Error Messages Are DisplayedWash results are not satisfactory Problems occur during use of the dishwasherDishes are still dirty Wrong wash programme was selectedDishes are wet and dull Technical DataRinse aid was not used Rinse aid container is empty Lower rinse aid dosingBottom rack with cutlery basket An open-end spanner Screwdriver Installing the DishwasherBuilt-In Dishwasher Dishwashers That Can Be IntegratedFree-Standing Appliances Work surface must be re-mounted Plinth on free-standing appliances is not adjustableFree-standing appliances can be Fitted with a décor panel to matchWater connection Connecting the DishwasherPermitted water pressure Connect the inlet hoseDrain hose Water drainExtension hoses Extension hoses are available fromElectrical connection Leak Prevention SystemAppliance is automatically pumped out Connections Egypt Kanada Mauritius E. Abu Dhabi Jordan MaltaAustralia Korea South Namibia Croatia New ZealandHongkong Lthuania Estonia LataviaIsrael Malaysia Japan SingaporeAutres agences étrangères assurant le service après-vente Further after-sales service agencies overseasWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroPage Service

6281 I specifications

The AEG 6281 I is an advanced built-in induction hob that combines elegant design with cutting-edge technology, making it a popular choice for modern kitchens. Known for its excellent performance and user-friendly features, this appliance demonstrates AEG's commitment to quality and innovation in kitchen devices.

One of the prominent features of the AEG 6281 I is its induction cooking technology. Induction hobs use electromagnetic fields to heat pots and pans directly, ensuring that the cooktop surface remains cool to the touch. This not only enhances safety but also promotes energy efficiency since heat is generated directly in the cookware, reducing heat loss and cooking time.

The hob provides a sleek surface with intuitive controls, which include touch controls that allow for precise temperature adjustments. Users can easily access various cooking levels, from gentle simmers to rapid boiling, ensuring versatility in cooking methods. The AEG 6281 I also incorporates a digital display that enhances the overall cooking experience by providing clear information about the selected power levels.

Another noteworthy aspect is the hob's flexible cooking zones, which accommodate different pot sizes, ensuring that every meal is cooked evenly and efficiently. This model features the bridging function, enabling users to combine two cooking zones into one larger area, perfect for griddle pans or large pots.

AEG has also integrated a range of safety features into the 6281 I, including a child lock to prevent accidental activation, automatic shut-off for safety if a pot is removed, and residual heat indicators that signal when the cooking zones are still hot.

Additionally, the hob's design pays homage to modern aesthetics, featuring a minimalist black glass surface that fits seamlessly into various kitchen styles. With a width of 60 centimeters, it is ideal for standard kitchen spaces while offering ample cooking surface for various culinary needs.

Overall, the AEG 6281 I represents a perfect blend of style, safety, and efficiency, making it an excellent choice for any cooking enthusiast seeking to elevate their kitchen experience. With its innovative technology and user-friendly features, this induction hob stands out in the competitive market of kitchen appliances.
Top Page Image Contents