Clock Setting, Standby mode | Morphy Richards 29118 REV2 specs

29118 rev2 8/8/06 13:05 Page 8

STANDBY

1Press the power button on the woofer cabinet, unit is in standby mode.

2Press STANDBY button on the CD unit (or remote) to switch the unit on.

3Select the sound source (CD, AUX, CARD-USB or TUNER) by pressing FUNCTION button.

The corresponding display will light up.

4Adjust the VOLUME with the volume (UP or DOWN) button

5Set the preset equaliser (PASS,

CLASSIC, ROCK, POP, OR JAZZ) with the EQ button on the remote.

6Press STANDBY button again on the CD to turn off the unit.

CLOCK SETTING

In the standby mode.

1Press and hold MEMORY/CLK- ADJ. button until the time displays 24-hour digit flashing.

2Press SEARCH/SKIP/TUNING (DOWN or UP) button to adjust 12 hour or 24 hour digit.

3Press MEMORY/CLK-ADJ. button again, the time display HOUR digit flashes, press

SEARCH/SKIP/TUNING (DOWN or UP) button to adjust HOUR digit; Press MEMORY/CLK-ADJ button once more, the MINUTE digit flashes, adjust it by the SEARCH/SKIP/TUNING (UP or DOWN) button.

4Press the MEMORY/CLK-ADJ button again to confirm the time.

5Each enable state as shown above will be cleared if the key is not pushed in 10 seconds.

6In the CD or TUNER mode. Press and hold the MEMORY/CLK-ADJ button a few seconds. To check the current time.

TIMER SETTING

(on the remote)

1After adjusting clock, press the D TIMER button for a few

seconds, ‘ON and 00:00’ appears on the display and the HOUR digit flashes. D.

2Press the SEARCH/SKIP/TUNING (UP or DOWN) button to adjust it.

3Press the TIMER button again, the MINUTE digit will start flashing, adjust it by pressing SEARCH/SKIP/TUNING (UP or DOWN) button.

4Press the TIMER button once more to confirm/order TIMER ON time.

5After adjusting ‘TIMER ON’, ‘

OFF’ appears on the display and the HOUR digit flashes. E

6Repeat the above steps 2 to 3, then press the TIMER button once more to confirm/order TIMER OFF time.

7Now the TUNER or CD appears on the display with flashing, adjust ‘TUNING’ or ‘CD’ by pressing the SEARCH/SKIP/TUNING (UP or DOWN) button.

8Press the TIMER button again, the timer ‘VOL 15’ indicator appears on the display and flashes, adjust the timer volume high or low by the SEARCH/SKIP/TUNING (UP or DOWN) button.

9Each enable state as shown above will be cleared if the button is not pushed in 10 seconds.

10After adjusting ‘TIMER ON” and ‘TIMER OFF’, press the TIMER

button. ‘ ‘ appears on the display.

11The unit will be switched on automatically at ‘TIMER ON’ and start playing and the unit will be switched off automatically at ‘TIMER OFF’.

Note: N.B Not available with USB or SD.

UK Helpline 0870 060 2614

Ireland Helpline 1800 409119