EUROPOWER EP1500/EP2500
4.1.1 Using the binding posts
To connect the loudspeakers to the amplifier’s binding posts, please do the following:
1.Switch off the amp and disconnect it from the mains (unplug mains connector).
2.Remove the protective plastic covers shielding the binding posts by loosening the two screws on the
3.Attach the terminal of your loudspeaker cable to the corres- ponding binding post.
4.Place the protective plastic covers into its original upright position on each binding post and replace the two screws.
Never operate the device without the protective plastic covers in place!
Fig 4.2: Protective plastic covers shielding the binding posts
When using binding post connectors, please make sure that insulation on cables is not removed too high. Insert the naked part of the cable fully so that no metal is visible. Cable clamps must be isolated to avoid the possibility of electric shock. When running the amp in
+ATTENTION! If you notice naked cable endings on the binding post connectors, do not power up the amp because of the risk of electric shock.
4.1.2 Connecting to the mains
Always connect your EUROPOWER amplifier to the voltage specified on the rear of the device. Connecting the amp to an incorrect voltage can permanently damage your amp.
Before powering up the amplifier,
4.2 Audio connections
Various cables are needed for different types of applications. The following illustrations show the correct wiring. Always use
+When connecting a balanced input signal, please make sure to exclusively use balanced cables for passing the signal further on. Otherwise, one single unbalanced cable can turn the entire signal unbalanced.
Fig. 4.2: XLR connections
Fig. 4.3: 1/4" TS connector
Fig. 4.4: 1/4" TRS connector
10 | 4. INSTALLATION |