Bosch Appliances SHU 3030, SHV 4300 manual Adding Rinse Agent, To Fill the Rinse Agent Reservoir

ADDING RINSE AGENT

Rinse Agent

Rinse agent, or a rinse aid, is used to provide optimum drying results and diminish water spot- ting. Always use a rinse agent with the Bosch dishwasher to insure proper drying results. It rinses the dishware and also rinses the internal parts of the dishwasher.

To Fill the Rinse Agent Reservoir:

1.Open the dishwasher door fully.

2.Open the cover of the rinse agent dispenser by pressing the star on the cover with your index finger while pulling on the tab with your thumb.

3.Add rinse agent to the reservoir until the level indicator turns dark, indicating that the reservoir is full (capacity is approx. 3.5 oz.).

Rinse Agent

Dispenser Regulator

The rinse agent reservoir of the Bosch dishwasher is provided with a regulator calibrated from 1 to 6. (See Figure 21.) This regulator controls the amount of rinse agent dispensed. The dishwasher leaves the factory preset to 4. However,

•if you see streaks, you should turn the regulator to a lower number.

•if you see water spots, you should turn the regulator to a higher number.

TO ADJUST RINSE

AGENT REGULATOR

SETTING:

1. OPEN THE COVER OF THE RINSE AGENT DISPENSER.

2.TURN THE SETTING INDICATOR TO THE DESIRED SETTING.

Figure 21

Note: Refill rinse agent when the level indicator shows a silver background with black lines.

Rinse agent level indicator

Figure 22

Rinse agent is available in liq- uid or solid form. Only use the liquid type of rinse agent in the Bosch dishwasher.

Rinse Agent Indicator Light

Some models are equipped with an additional rinse
aid indicator light on the control panel. When the
rinse agent dispenser is empty, the indicator light will
glow and the level indicator will show a silver back-
ground with black lines.
After filling the rinse agent dispenser, close the door	Figure 23
and wait a few minutes for the indicator light to reg-
ister.

www.boschappliances.com ENGLISH - 13