Grundig CLASSIC 960 Fine Tuning Shortwave Stations, For CD Connection, Precautions

O P E R A T I O N G U I D E

GETTING THE BEST SHORTWAVE RESULTS WITH

YOUR GRUNDIG CLASSIC 960

Listening to shortwave stations on the Grundig Classic 960 is done just like it was back in the 1950’s. Best results are in very late afternoon and at night with a long- wire antenna attached to the back of the radio. With this your Classic 960 will bring the world into your home! Some stations will be strong, others will fade in and out with an almost eerie sense to them. This is all part of the mystique of shortwave radio.

FINE TUNING SHORTWAVE STATIONS

Please be sure to read the materials that come with your Classic 960 to learn about shortwave bands, the best time for listening, etc. To get the best results when actually tuning in a station, please do the following.

This style shortwave tuner requires that you develop a “feel” for fine-tuning a station. On shortwave this is much more critical than on AM/FM. To do this, turn the tuning knob very, very slowly and deliberately.

Sometimes when trying to “capture” a station, you will zip right buy it and have to back up and try to fine-tune it again. This is normal. Don’t get discouraged, simply back up and try again. You will develop a feel for doing this a few times.

FOR CD CONNECTION

Special auxiliary inputs are provided for use with a CD player, tape, records or VCR. Connection requires standard RCA connectors when using inputs.

ATTACHING THE EXTERNAL ANTENNA

An auxiliary shortwave is supplied with your Grundig Classic 960 it is housed in a black plastic container and, when fully unrolled is about 20 feet long. Always fully unroll it for best results.

1.Fully unroll the supplied shortwave antenna.

2.Plug it into the special shortwave antenna socket in the back of the radio.

3.Run the antenna wire as high off the floor as possible, back and forth across a window. Use the string clip, attached to the antenna’s back plastic container, to hang the end of the antenna to a high point. Do not connect external antenna to an outside antenna.

O P E R A T I O N G U I D E

TECHNICAL DETAILS
Power Requirements:	20Vor, 60Hz
Power Output:	7.3W (at 10% harmonic distortion)
Tuning Ranges:	FM 88-108MHz
	AM 530-1710KHz
	SW 4.5-22MHz
Antenna:	Built-in ferrite bar antenna
	External antenna terminal
Dimensions:	15.25”L x 11.25”H x 6.5”D
Weight:	4.2KGs
Cabinet:	Polished wooden cabinet with hand painted trim
Speaker:	130mm 16 Ω 10W - 1 and 66mm 8 Ω 0.1W

PRECAUTIONS

•Operate the set only on 120V or 60Hz

•The nameplate including voltage, power consumption, etc. is located on the rear exterior.

•Unplug the set from wall outlet when it is not being used for an extended period of time. To disconnect the cord, put it out by grasping the plug. Never pull it by the cord.

•Do not install the set in a location near heat sources such as radiators or air ducts, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock.

•Allow adequate air circulation to prevent internal heat build-up. Do not place the set on surfaces (rugs, blankets, etc.) or near materials (curtains, draperies) that may black the ventilation holes.

•Should liquid or solid object fall into the set, unplug the set and have the set checked by qualified personnel before operating it any further.

•When the wooden cabinet becomes soiled, clean it with a soft cloth dampened with a mild reputable furniture polish. Never use abrasive cleaners or chemical solvents, as they may mar the cabinet.

•When an external antenna is used, disconnect it form the antenna terminals of the set during a lightning storm, unless the installation incorporates a suitable lightning resistor.

8 9