Panasonic FV-08VKSL2, FV-08VKML2 Insert the plug connector II into the receptacle

INSTALLATION (JOIST MOUNTING- ) CONTINUED

7.	Finish ceiling work. Ceiling hole should be aligned
	with the edge of the flange. (Fig.5)	Plug connector II
8.	Insert the plug connector II into the receptacle II,	Ceiling
	and secure the lighting unit to the fan	Lighting unit
	body with 1 screw III (ST4.2X16) and 2 machine
	screws (M4X8). (Fig.5)

CAUTION:

The machine screws must be tight fit.

Machine screw

(M4X8) Receptacle II

Machine screw Screw III (ST4.2X16)
(M4X8)	Plug connector II

9.Insert the fluorescent lamps and secure the night lamp into the lighting unit . (Fig.5)

10.Insert mounting spring into the slot as shown and adjust high/low delay time preset switch and low speed air volume preset switch. Refer to switch indication on page 5 (FV-08VKML2) (Fig.6-1)

11.Insert the sensor unit into the housing of the grille and insert other mounting spring into the slot as shown and mount grille to fan body (FV-08VKML2) (Fig.6-2, Fig.6-3)

CAUTION:

Mount grille carefully so that lead wire of sensor unit is not pinched.

12.Insert mounting springs into the slots as shown and mount grille to fan body. (FV-08VKSL2) (Fig.7)

Fluorescent lamps	4 W Night lamp
Inches (mm)	Fig.5
Ceiling

	Sensor unit		Gloves
Grille	Lighting unit		Fig.6-1
Ceiling
Grille			Sensor unit
			Gloves
			Fig.6-2
Ceiling		Mounting spring
Grille			Gloves
			Fig.6-3
Slot	Lighting unit	Mounting spring
			Ceiling
			Gloves

Grille Fig.7

10