NT 250 PROGRAMMING
Connect a 50 ohm load or 50 ohm antenna to the RF output, connect the equipment into a mains supply (100÷240 VAC). The equipment is factory
Switch ON the power and the yellow V POWER LED will light.
The Display will show:
WAIT
PROGRAM
SETTING
After 3 seconds the green PLL LOCK led will light and the Display will show an increasing bar. After a further 5 seconds the green ENABLE will light and there will be output power.
WAIT
PROGRAM
SETTING
At this point the Display will show the next parameter:
•Level Modulation (MOD >
);
•Forward Power (FRW 50.0W);
•Reflected Power (RFL 0.4W).
MOD > 
FRW 50W RFL 0.4W
PROGRAM
SETTING