10.Install finger in the oven by sliding it over the plenum flange and setting the front bracket. BE SURE THAT THE FINGER SETS SQUARELY OVER THE PLENUM FLANGES AND THE HOLES POINT IN THE PROPER DIRECTION. Top fingers point down, bottom fingers point up.
12.Attach Motor Cover as shown with bolts provided.
11.Repeat step 10 until all ten (10) fingers are installed.
Install conveyor and crumb pans before operation. See page 17 for conveyor installation instructions.
FINGER HOUSING BAFFLE PLATE ADJUSTEMENTS
The finger housing has a baffle mounted inside to balance the air flow to the rear and front of the oven. If the product is cooking more or less in the rear of the oven than in the front, it is possible the finger housing baffle needs to be adjusted. If it is deemed necessary to adjust the air balancing baffle, be sure to adjust all ten (10) finger housing to exactly the same opening. Determine if more air (heat) is required at front or rear of oven then open or close off that air by bending the baffle in the proper direction. For additional information on how to adjust the Finger Housing Baffle Plate, contact the Lincoln Technical Service Department at (800)
Impinger 3255 – Operator Manual | 11 |