Installation
| FREE STANDING INSTALLATION |
Choose the location
. Be sure the front of the appliance is unobstructed for air circulation and proper access to the door.
. Do not install the appliance where the temperature will go below 55°F or above 90°F.
. Do not install where it will be subject to direct
sunlight, heat or moisture.
. Allow sufficient space for door swing.
. This unit is not designed for use in garage or any other outside installation.
The cutout depth must be 24".
The cutout dimensions shown allows for a full door swing and access to the
. The appliance can be installed freestanding.
. If installing between frameless cabinets, a 1/2" wide filler strip or side panel may be needed on hinge side. The filler strip will act as a spacer between the
appliance case and adjacent cabinet door swing.
The width of the opening must include the filler panels. Note: The door should protrude 1" beyond the surrounding cabinets.
Additional Specifications
. A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded
Consult a qualified electrician or serviceman if the wiring instruction are not clearly understood, or if doubt exists as to whether the appliance is properly grounded.
Adjustable Feet
Some appliances have adjustable feet on the front side; use them to level the appliance.
Note: If you want to change door swing, change it before installation.
3