Maintenance and Cleaning

Automatic Defrosting of the Appliance

There is no need to defrost the appliance, because ice depositing on the inner back wall is defrosted automatically.

Ice build-up on the inner back wall during the compressor operation will defrost automatically (when the compressor has cycled off) . Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan situated above the compressor, from where it evaporates.

Correct Steps to Change Bulb

1.Pull out the power plug from wall socked. Use a screw driver to loose the screw that holds the bulb protective cover and then remove the cover.

2.Screw out the old bulb counter-clockwise.

3.Screw on a new bulb (E14, max. 15W) clockwise.

4.Replace the bulb protective cover.

Very important: Be sure to disconnect power supply before you change bulb.

Cleaning the Appliance

Disconnect the power supply before cleaning the appliance.

Do not use coarse or aggressive cleaning agents as you may damage the surface. Clean the exterior with water and detergent. Remove the detachable accessories in the

interior of the appliance and clean with water and liquid detergent. Plastic parts cannot be washed

in dishwashers.

Wash the interior of the appliance with lukewarm water , adding one or two spoonfuls of vinegar. After cleaning, connect the appliance to power supply and reload it.

Switch Off the Appliance When Not In Use

If you do not intend to use the appliance for long periods of time, disconnect the power supply,

take out the contents and defrost and clean the appliance. Leave the door slightly open.

This unit is not designed for outside installations such as garage or porch.