Magic Chef MCWBC77DZC instruction manual Troubleshooting Guide, Problem, Possible Cause

TROUBLESHOOTING GUIDE

You can solve many common appliance problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling for service.

PROBLEM	POSSIBLE CAUSE
Appliance does not operate.	Not plugged in.
	The circuit breaker tripped or a blown fuse.
Temperature inside the appliance is too warm.	Temperature control is set too warm.	Turn the
	control to a cooler setting and allow several hours
	for the temperature to stabilize.
	Door is kept open too long or is opened too
	frequently. Warm air enters the appliance every
	time the door is opened. Open the door less
	often.
	The door is not closed completely.
	The door gasket does not seal properly.
	The appliance has recently been disconnected
	for a period of time. 4 hours are required for the
	appliance to cool down completely.
Temperature inside the appliance is too cold.	Temperature control is set too cold.	Turn the
	control to a warmer setting and allow several
	hours for the temperature to stabilize.
Vibrations.	Check to assure that the appliance is on a level
	surface.
	The appliance is touching the wall. Re-level the
	appliance and move it from the wall.
	If continued vibration occurs, turn off the
	appliance and unplug the power plug. Contact
	Customer Service Dept. for further assistance.
Moisture forms on inside appliance walls.	Door is slightly open.
	Door is kept open too long, or is opened too
	frequently. Open the door less often.
	The door is not sealed properly.
Moisture forms on outside of appliance.	Door is slightly open, causing cold air from inside
	the appliance to meet warm moist air from
	outside.
The door will not close properly.	The appliance is not on a level surface.
	The gasket is dirty.
Abnormal display on control panel	“E1” on display for upper zone – error of
	temperature sensor for upper zone.
	“E2” on display for lower zone – error of
	temperature sensor for lower zone.
	“E3” on display for upper zone – error of DC
	electric fan for upper zone.
	“E4” on display for lower zone – error of DC
	electric fan for lower zone.
	If any of above errors happens, please contact
	Customer Service Dept. for further assistance.
	Do not attempt to repair it yourself.

8 EN