Problems & Solutions
Problem | Solution | |
Receiver signal L.E.D. flashes | Receiver is out of range of transmitter. Move receiver closer | |
| to transmitter. | |
| Note: Range varies depending on surrounding conditions such | |
| as noise levels, physical obstructions and signal interference. | |
| Under optimal conditions, the range is up to 244 meters. | |
| Transmitter power is off. Turn transmitter power on. | |
| Loose power cord connection and transmitter power is off. | |
| Check transmitter power cord | |
| No power to wall outlet and transmitter power is off. Make sure | |
| light switch that controls power flow to wall outlet is on. | |
| Power is off because circuit breaker for room is off. Make sure | |
| house fuses and circuit breakers are on. | |
Receiver power/battery | Receiver power is off. Turn receiver power on. | |
L.E.D. does not light |
| |
Batteries in receiver are weak or dead. Use AC adaptor as power | ||
| ||
| source and to charge the battery. | |
|
| |
| Power is off because circuit breaker for room is off. Make sure | |
| house fuses and circuit breakers are on. | |
| No power to wall outlet and power is off. Make sure light switch | |
| that controls power flow to wall outlet is on. | |
Receiver power/battery | Batteries in receiver are weak or dead. Use AC adaptor as power | |
L.E.D. flashes | source and to charge the battery. | |
|
| |
Transmitter power L.E.D. does | Transmitter power is off. Turn transmitter power on. | |
not light |
| |
Loose power cord connection and transmitter power is off. | ||
| ||
| Check transmitter power cord | |
|
| |
| No power to wall outlet and transmitter power is off. Make sure | |
| light switch that controls power flow to wall outlet is on. | |
| Power is off because circuit breaker for baby’s room is off. | |
| Make sure house fuses and circuit breakers are on. | |
|
| |
You can hear conversations or | There is signal interference due to other nursery monitors on | |
sounds from other homes | same channel or cordless telephone use. The monitor should | |
| automatically find a new channel to avoid interference. | |
|
| |
Receiver is not picking up | You may need to pair the receiver and transmitter. Turn over the | |
sounds from transmitter | receiver and press the pairing button with a pen. Then, turn over | |
| the transmitter and press the pairing button with a pen. The signal | |
| L.E.D. on the receiver will flash and you will hear a tone. |
15