Operating Lips | Maytag 9922, 9902 manual

Operating

lips

.......................................................

Starting

The Dishwasher

To Set

Up a Delay:

[]

After

loading the dishwasher

and adding detergent,

[]

Select

the appropriate

cycle and options

for

the

the dishwasher by pressing the

door until the

load.

latch clicks.

[]

Then

quickly

press and hold

the Delay/Resume

pad

]

If the

water heater is located

a long

distance from

until

the desired amount

of delay

time is displayed.

the dishwasher, run the water

from the hot water tap

[]

The DELAY

indicator will remain

lit until the clock

to clear the line of cold water.

has counted

down.

[]

Firmly press the desired cycle

and OPTIONS pads

[]

The cycle will automatically

start as soon

the

to start the dishwasher ( fill will begin),

delay time expires.

[]

The indicator light for the selected cycle will glow.

Note: Water heating and dry options can be used

cycle and/or options, the dishwasher will select the

separately

or together,

last wash cycle

used in the delay mode.

I Note; If delay is chosen without first selecting a

Adding

a Forgotten

Item

To Cancel

a Delay:

For

best cleaning, the forgotten

item should be added

Press the Delay/Resume

pad

again. The indicator light

early in the cycle,

will go out and the cycle will start immediately.

]

Unlatch

the door.

To Temporarily Interrupt a Cycle:

[]

Wait for the water circulation

to stop.

[]

Open the door and add the item.

[]

Press the Delay/Resume

pad.

[]

Close and latch the door,

[]

The cycle

will stop.

[]

The cycle resumes automatically.

[]

The cycle

will resume

from the point of interruption

when the delay time expires or when the

Delay/Resume pad is pressed again.

_eeoeeooleoeeoeeoeoo*leoQeeo*leeleeoeooolooeeooetoee

Display

Window

WASH light glows during all wash

portions.

HEATING

DELAY glows to indicate

that the cycle is

RINSE light

glows during all rinse

portions,

being extended

to heat the water

to proper temperature

DRY light glows during the entire dry period and goes

RINSED ONLY (certain models) appears after

out when the cycle is completed.

RINSE & HOLD

cycle.

CLEAN glows at the end of the dry cycle and remains

PF appears when there has been a power failure. Pres

lit until the door has been open for 30 seconds coutinu-

any option pad (Temp Sense, Heated Dry or Sani Heat

one time to clear the display.

oasly.

DELAY glows when this option is selected. The light stays on until the start of the cycle.