Maytag 6 915928 A Clean Controls at a Glance, Cycles, Water Usage, Options, Indicator Lights

Auto

Clean Controls at a Glance

Control panel style may vary by model.

Cycles

Auto Clean

Manufacturer’s recommended cycle choice for all day- to-day soil types.

Normal dishloads vary from day to day. Auto Clean is recommended because it adjusts to each load, offering the best combination of cleaning, energy consumption and water usage for that load.

Standard cycles:

Heavy Wash

Long cycle for heavy food soils.

Normal Wash

Medium cycle for average food soils.

Light Wash

Short cycle for light food soils.

Rinse Only

Rinses dishes being held until there is a full load. Controls odors.

Cycle times shown in the numerical display increase or decrease, based on each load’s soil level, water tem- perature and selected options.

Water Usage

	—————	Auto Clean———————
	————	Normal————
Rinse	Light			Heavy
Only
1 Fill	2 Fills	3 Fills	4 Fills	5 Fills
2.1	4.1	6.0	8.0	9.9
gallons	gallons	gallons	gallons	gallons

Options

Select Tough Scrub™ Plus when washing loads with hard-to-remove food soils.

Tough Scrub™ Plus can be selected with any cycle (except Rinse Only). Depending on which cycle is being used, selecting Tough Scrub™ Plus adds fills, heat and/or wash time to the wash cycle.

For baked-on, dried-on soils, select Heavy Wash along with the Tough Scrub™ Plus option. The use of an enzyme deter- gent (such as Cascade Plus or Electrosol Tabs*) is recom- mended.

Select Sanitize with Auto Clean, Heavy, Normal, or Light Wash to sanitize dishware. At the end of the cycle, when the cycle monitor recognizes that the proper condi- tions have been met, the SANITIZED light illuminates.

Select Extra Rinse to add a rinse to the cycle. An extra rinse helps to improve results in hard water situations. The extra rinse is already built into the cycle when Heavy Wash is selected.

Select Heated Dry to turn on the heating element during dry for enhanced drying results. When Heated Dry is not selected, towel drying of some items such as plastic and teflon may be necessary and more moisture may be noticed adhering to the dishwasher interior. With either dry option, it is normal to notice vapor escaping from the door vent.

To drain the dishwasher and then turn it off, press Drain/Off once. Press Drain/Off twice to turn the dish- washer off without draining.

Indicator Lights

The SANITIZED light illuminates at the end of the cycle when conditions have been met to achieve sanitization.

Note: When Sanitize is selected, cycles are monitored to assure sanitization. Unusually low water temperature will prevent the sanitization protocol from being satisfied and the SANITIZED light will not illuminate at the end of the cycle.

The CLEAN light illuminates at the end of the cycle and remains lit until the door has been open for 30 seconds continuously.

The DRY light illuminates during the entire dry period and goes out when the cycle is completed.

The WASH light illuminates during all rinse and wash portions of the cycle.

The HEATING DELAY light illuminates when the cycle is being extended to heat the water.

The CLEAN and SANITIZED indicator lights will not re- illuminate after a power failure until after the next cycle is run.

* Brand names are trademarks of the respective manufacturer. 6