Extron electronic TP Receivers user manual Through-desk Mounted

Installation and Operation, cont’d

All models except the TP R 15HD A can be mounted through a table or podium using an Extron Through-Desk Mounting Kit for 1/4 or 1/2 Rack Width Products (part #70-077-02). Furniture mount the receiver as follows:

1. Attach the mounting brackets to the receiver with the machine screws provided (figure 2-5).

OIDUA
V
UTPUT
HV/	H	O	BRG

B

G

R

TUPNI

GBR

Extron

TP R BNC A

Through-desk

Mounted

Extron

TP R BNC A

AUDI O

	V
	H/HV
	OUTPUT
B	RGB

G

R

INPUT

RGB

Extron

TP R 15HDA

RGB

LEVEL

TP	PE
	R	AK
			ING
		15HDA

Under-desk

Mounted

Under-desk

Mounted

Figure 2-5 — Under-desk or through-desk mounting

2. For through-surface mounting (all except TP R 15HD A), cut the proper sized hole in the mounting surface.

3. Hold the receiver with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.

4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.

5. For through-surface mounting (all except TP R 15HD A), insert four #8 wood screws through the bracket and into the four pilot holes. Tighten all four screws to secure the receiver in place.

6. For under-surface mounting, insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until slightly less than 1/4" of the screw protrudes.

2-10 TP Receivers • Installation and Operation