Extron electronic 15HD setup guide Mounting, Transmitter Inputs, TP Cables Between Units

MTP 15HD A Series • Setup Guide

					ANT:				complete
				T				the
	IMPOR.com						for			and
							instructions,
	.extr
to		on							the
	,installationoreconnectingce
	www								.
Go guide			bef				wersour
user				the		po
specifications
	product		to

This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and audio transmission systems.

Installation

Step 1 — Mounting

Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers as required.

Step 2 — Transmitter Inputs

•Connect a computer (VGA) video source to the Input connector.

•Connect a VGA monitor to the Monitor connector.

•Plug a 3.5 mm stereo audio plug into the audio jack.

Step 3 — TP Cables Between Units

•Terminate a TP cable as shown at right. Connect it between the transmitter’s Output port and the receiver’s Input port.

NOTE: If the unit is labeled “C7,” only CAT 7 cable should be used.

•For daisy-chaining, connect up to eight TP cables between a receiver’s Buffered Output port and a daisy-chained receiver’s Input port.

Step 4 — Receiver Outputs

•Connect a VGA monitor to the Output connector.

•Connect a mono audio device to the Mono Audio connector. Wire the connectors as shown below.

ATTENTION: Connect the sleeves to ground (Gnd).

Connecting the sleeve to a negative (-) terminal will damage the audio output circuits.

	Mono output 1	MONO 1	Mono output 1+	MONO 1
	NO GROUND.		Mono output 1-
	Sleeve(s)	AUDIO 2	Sleeve(s)	AUDIO 2
Do not tin the wires!	Mono output 2		Mono output 2+
	NO GROUND.		Mono output 2-

Unbalanced Output Balanced Output

AUDIO

			INPUT	MONITOR
			T568A	T568B
	Pins:	Pin	Wire color	Wire color
12345678		1	White-green	White-orange
		2	Green	Orange
		3	White-orange	White-green
		4	Blue	Blue
		5	White-blue	White-blue
		6	Orange	Green
Insert Twisted
		7	White-brown	White-brown
	Pair Wires
		8	Brown	Brown

NOTE: If you are using Enhanced Skew-Free™ AV cable, use the TIA/EIA T568A standard only.

MONO AUDIO

1 2

OUTPUT

Step 5 — Receiver DIP Switches

•H Sync and V. Sync switches — Set these switches up for positive sync or down for negative sync.

•Composite Sync, (SOG), and Video switches — Set these switches as shown in the table below to output the indicated format.

Output Format	C Sync	SOG	Video
RGBHV			
RGBS			
RGsB			
Component*			
S-Video*			
Composite*			

NOTE: * Input video format must match.

•End Unit switch — Set this switches up if either of the following is true:

•The receiver being configured is the only receiver connected to the transmitter.

•The receiver being configured is the last receiver in a daisy-chained system.

H SYNC + V SYNC + C SYNC SOG VIDEO END UNIT

ON

1 2 3 4 5 6