BUNN Espress™
ELECTRICAL
ES•2A™/ES•2SA™
ELECTRICAL SPECIFICATIONS
This brewer requires a
Hz.
ELECTRICAL HOOKUP
CAUTION: Improper installation will damage electronic components.
1.An electrician must provide electrical service as specified.
2.Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.
3.The plug for the brewer is to be supplied by the installer.
4.Attach the plug to the brewer cordset as shown below:
L1
240V or 208V
L2
Gnd
Red
Blk
Grn
From brewe
5.Attach wires from pump cordset to terminal block located on pump motor as shown below:
Brn
Blu
Terminal
block
Cover
Grn/Yel
Blu
Blk
Grommet Compression nut
NOTE: Wiring going into the terminal block must be tinned with solder to insure proper connection.
Warning: The brewer and pump must be electrically grounded. Do not assume that a plumbing line will provide an adequate ground.
7