Extron electronic FOX HD-SDI user manual Installation and Operation, cont’d, Furniture mounting

Installation and Operation, cont’d

1U Universal Rack Shelf	1/2 Rack Width
	Front False
	Faceplate 1/4 Rack Width
	Front False
	Faceplate

Both front false faceplates use 2 screws.

Use 2 mounting holes on opposite corners.

(2) 4-40 x 3/16" Screws

Figure 2-3 — Under-desk mounting

Figure 2-2 — Mounting the transceiver on a standard rack shelf

5.	Secure the shelf to the rack using the supplied machine
	screws.

Furniture mounting

The transceiver can be mounted under a horizontal surface using an optional MBU 125 under-desk mounting kit (part #70-077-01). Mount the unit under a desk or table as follows:

1.	If rubber feet were previously installed on the bottom of
	the unit, remove them.
2.	Secure the under-desk mounting brackets to the
	transceiver with the four machine screws provided in the
	mounting kit (figure 2-3).
3.	Hold the transceiver with attached brackets against the
	underside of the desk or other furniture. Mark the location
	of holes for screws on the desk.
4.	Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
	holes in the table or desk at the marked screw locations
	from the underside or inside (the concealed side) of the
	furniture, where the transceiver will be located.
5.	Insert the four wood screws into the pilot holes. Fasten
	each screw into the installation surface until just less than
	1/4" of the screw head protrudes.

6.	Align the installed screws with the slots in the mounting
	brackets, and place the transceiver against the surface,
	with the screws through the bracket slots.
7.	Slide the transceiver slightly forward or back, then tighten
	all four screws to fasten it in place.

2-4 FOX HD-SDI • Installation and Operation FOX HD-SDI • Installation and Operation 2-5