Extron electronic FOX HD-SDI user manual PMK 350 mounting, You are finished

Installation and Operation, cont’d

3. Use the two included tie wraps to strap the power supply to one of the brackets.

NThe PMK 300 has a hole in the bottom plate that allows the projector pole to be inserted through the center of the plate (figure 2-6), rather than outside of the plate (figure 2-5).

To install the PMK 300 in this configuration, slide the bracket up from the bottom of the pole before the projector is installed on the pole.

Bracket

Brace

U-Bolt	Extron
	PMK 300

Multi-product Projector

Mount Kit

Figure 2-6 — Projector pole on the inside

4.	Place the contoured bracket brace against the pole and
	opposite the back plate. The pole should fit snugly into the
	depression in the center of the bracket brace.
5.	Place the U-bolt around the ceiling pole and insert the
	two legs of the U-bolt through the round holes on the
	contoured bracket brace and then through the slotted holes
	on the bracket’s mounting plate.

NThe supplied U-bolt fits a typical (1.5" to 2.0" diameter) ceiling pole.

6.	Secure the bracket to the U-bolt with the included hex
	nuts, washers, and lock washers. Tighten the hex nuts just
	enough that they can be loosened by hand.

PMK 350 mounting

Mount the transceiver to a PMK 350 bracket as follows:

1.	Remove the front and back plates from the PMK 350
	(figure 2-7), using an Extron Tweeker or a #2 Philips
	screwdriver. Retain the screws to reattach the plates when
	you are finished.
		Extron
Rear Plate		Quarter-rack
		Sized Product
		Contoured
		Base
		L-shaped
		Bracket
Extron	U-bolt
PMK 350
Multi-product Projector
Mounting Kit
	Extron
	Power Supply	Front Plate

Cover Sheet

Figure 2-7 — PMK 350 projector mounting a transceiver

2.	If necessary, remove the feet from the bottom of the
	receiver.
3.	Secure the transceiver to one side of the mounting tray,
	using two of the supplied 4-40 x 3/16" screws in opposite
	(diagonal) corners.
4.	Use the two included tie wraps to strap the power supply
	to the bracket.
5.	Place the PMK 350 around the projector ceiling mounting
	pole (figure 2-7, above).

2-8 FOX HD-SDI • Installation and Operation FOX HD-SDI • Installation and Operation 2-9