CDA SV500 General Settings and Use, Clock, Display brightness adjustment, Set the clock to Touch

Page 7

General Settings and Use

Clock

To set the clock when the time and the clock indicator are flashing (for example, when the oven is first switched on) touch or until the correct time shows on the display, then touch to confirm the selection. The oven will beep to confirm the selection and the clock and clock indicator will stop flashing.

To set the clock once the time has been set (when the clock is not flashing) touch and hold for three seconds until the clock and the clock indicator flashes. Touch or until the correct time shows on the display, then touch to confirm the selection. The oven will beep to confirm the selection and the clock and clock indicator will stop flashing.

Please note: the clock will set automatically if no key is touched for eight seconds.

Minute minder

This oven is equipped with a minute minder to count down for a maximum of 60 minutes. To set the timer, touch so the display flashes 0:00 and the minute minder indicator flashes. Touch or until the required time shows on the display. The minute minder will set after eight seconds delay and starting counting down. To start the minute minder immediately, touch .

The display will show the time remaining and the minute minder indicator will stay lit. At the end of the countdown, the minute minder indicator will flash and the oven will beep intermittently for approximately 2 minutes. To stop the end of timer alerts before that time, touch any key.

To check on the progress of the minute minder during cooking, touch until the minute minder indicator flashes and the time remaining will show on the display.

To cancel the minute minder touch until the minute minder indicator flashes and then touch or until the display shows 0:00.

General Settings and Use

Display brightness adjustment

Set the clock to 00:10.

Touch

and

 

 

together for 10 seconds until the display shows –CO–.

 

 

Touch

or

 

 

until the required brightness shows on the screen.

 

 

After eight seconds delay, the oven will confirm the setting. Then set the clock to the correct time of day.

6

Image 7
Contents SV500 Pyrolytic Oven Appliance information User informationCE Declarations of Conformity First use of the oven Using the touch controlUsing your oven Control Panel and Display Fitting Out Your Appliance Set the clock to Touch General Settings and UseDisplay brightness adjustment ClockTo programme the oven Low temperature cooking- preset 80˚ range available 35-100˚ Fanned Grill preset 200˚ range available 180-230˚Conventional Eco Oven preset 200˚ range available 35-275˚ Fan With Lower Heat preset 205˚ range available 35-275˚For Each Grill FUNCTION, Please Note Medium Pyrolysis ProgrammesStainless steel Cleaning and MaintenanceEnamelled parts Changing the Oven Lamp RongCleaning the interior of the door Care and MaintenanceClac Problem Possible Cause Advice TroubleshootingError Code Fault Height mm 594 585 Width mm 592 560 Depth mm InstallationHow to install your oven Dimensions Oven HousingMains Electricity Connection Page Customer Care Department 01949 862