XTRA™ Full Rack Series • Setup Guide
This guide provides basic instructions for an experienced installer to set up and operate the Extron® XTRA Full Rack Series of power amplifiers. All references refer to the
XTRA Full Rack Series: XPA 2002, XPA
|
|
|
|
| : |
|
|
| TANT .comfor | ||||
| IMPOR | on | and | |||
|
| .extr | guide | |||
| to | www | user | . | ||
complete |
| instructions | ||||
Refer |
|
|
|
|
|
|
the |
|
|
|
|
|
|
installation |
|
|
|
•XPA 2002 outputs stereo audio at 200 watts rms per channel
100 watts rms per channel
•
•
•XPA 2004 outputs stereo audio at 200 watts per channel
Installation
NOTE: Adjust the audio level to = prior to the amplifier being powered back up in step 5. |
See “Rear Panel Features and Operation” in the user guide. |
1.Turn off all equipment including the XPA amplifier by toggling the power off and disconnecting the power cords. Verify that the amplifier is disconnected from the power source before proceeding.
2.Mount the amplifier — For diagrams of typical application examples, see “Application Examples” in the user guide. For further mounting instructions, see “Mounting the XTRA Series of Power Amplifiers” in the user guide.
3.Wire input to the 3.5 mm input connectors of the amplifier, as shown in the following illustration. See “Rear Panel Features and Operation” in the user guide for bridging
information. |
|
|
| 1 |
|
|
|
| |
" (5 mm) MAX. | Tip | Tip |
| (BRIDGE) |
|
| |||
| Sleeve | Ring |
|
|
|
| Sleeve |
|
|
| Unbalanced Input | Balanced Input |
|
|
|
| 1 | 2 | 3 |
|
| (BRIDGE A) |
| (BRIDGE B) |
The wires must not be tinned: tinned wire does not |
|
| ||
hold tight in the captive screws and can break easily |
|
| ||
after several bends. |
|
|
|
|
2
4
4.Wire the outputs — Wire speakers to the output connectors of the amplifier using the included
(XPA
2-pole (70 V) output connector wiring:
1
Do not tin the wires!
OUTPUTV 70
4-pole (8 ohm or 4 ohm) output connector wiring:
1 2
Do not tin the wires!
OUTPUT2 1