Cuisinart WCH-950C manual Performance data sheet

performance data sheet

PERFORMANCE DATA SHEET FOR MODELS WCH-850C and WCH-950C

CONTAMINANT REMOVAL DATA IMPORTANT NOTICE:

Read this Performance Data Sheet and compare the capabilities of this unit with your actual water treatment needs. It is recommended that, before purchasing a water treatment unit, you have your water supply tested to determine your actual water treatment needs.

Performance testing conducted by NSF International. These systems have been tested according to NSF Standard 53 and 42 for reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified in NSF Standard 53 and Standard 42.

Testing was performed under standard laboratory conditions; actual performance may vary.

			Removal	Removal	Action Level	Hardness	Temp	Inlet
		Influent	Filter		Max.
	Influent			Percent	Premissible		Testing
Substance		Challenge	Effluent			CaCO3			Reduction
	Water Avg.			Reduction	Product Water		Compart.	PH
		Concentration	Max.			(ppm)			Requirement
	(ug/L)	(mg/L)	(ug/L)	(%)	Concentration		(°C)
					(mg/L)

NSF/ANSI Standard 42-Aesthetic Effects

Chlorine Taste and Odour Reduction

2.0

2.0+/-10%

N/A

97.5%

N.A.

N.A.

20

7.53

>50

NSF/ANSI Standard 53-Health Effects

Copper	3150	3.0+/-10%	870	85.0%	1.3	16	20	6.42	N/A
Copper	3100	3.0+/-10%	1000	85.4%	1.3	120	19	8.42	N/A
Mercury	6.2	0.006+/-10%	0.9	92.8%	0.002	22	19	6.45	N/A
Mercury	5.7	0.006+/-10%	1.2	89.9%	0.002	140	20	8.55	N/A
Cadmium	28.8	0.03+/-10%	2.2	96.6%	0.005	18	20	6.59	N/A
Cadmium	300	0.03+/-10%	4.0	92.5%	0.005	120	20	8.44	N/A
Benzene	15	0.015+/-10%	3.4	84.1%	0.005	130	20	7.58	N/A
Toluene	2900	3.0+/-10%	770	89.8%	1	320	20	7.54	N/A
Tetrachloroethylene	14	0.015+/-10%	3	92.5%	0.005	340	21	7.56	N/A