Installation and Setup, cont’d
Under-desk mounting
Mount the FOX 2G Tx/Rx AV under a desk or podium using the optional Extron MBU 125 under desk mounting kit
(PN
1. Remove the rubber feet if these have been installed on the bottom of the unit.
2. Secure the mounting brackets to the transmitter or receiver, using the four
Figure 2-2 — Under-desk mounting
3. Hold the unit with the brackets attached against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.
4. Drill four pilot holes, each 3/32" (2 mm) in diameter by 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4" (6.3 mm) of the screw head protrudes.
6. Guide the mounting screws through the slots in the brackets and place the unit tight against the surface.
7. Slide the unit slightly in or out so that the screws are seated in the narrowest part of the mounting bracket slots; tighten all four screws to secure the unit in place (see the figure above).