Starting the Appliance

Starting a wash cycle...

-Make sure that the plug for the appliance is inserted into the wall socket.

-Make sure that the water supply is turned on to full pressure.

-Load the dishwasher (see the section entitled, "Loading the Dishwasher").

-Pour in the detergent (see the section entitled, "Salt, Dergent and Rinse Aid").

-Turn the knob located on the right of the control panel in the clockwise direction until the number or symbol for the cycle set- ting is aligned with the reference mark (see the section entitled, "Wash Cycle Table").

-Press the ON-OFF button, and the ON-OFF light will turn on. At this point, the wash cycle will begin.

Cancelling or modifying a wash cycle setting

Press the ON-OFF button and the ON Light will turn off. Rotate the knob in the clochwise direction to the desired cycle setting (see the section entiled, "Starting a wash cycle...").Then, turn the dishwasher back on using the ON-OFF button.

At the end of the wash cycle...

When the knob stops turning and is aligned with a STOP mark (see figure), the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher.

Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better.

Stop

Wash Cycle adjustment Buttons

1/2 load Button

ECO Button

This button (see "close-up View - Control Panel", letter "C") make it possible to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and electrical energy.

This button (see "close-up View - Control Panel", letter "B") is used in the normally dirty dishes, pots and pans. It is standard daily cycle.

.6.