Cleaning and Special Maintenance
Filter Assembly
For the best performance and results, the filter assembly must be keep clean.
The filter removes food particles from the wash water, allowing the water to be recirculated during the cycle. For this reason, it is a good idea to remove any food particles trapped in the filter after each wash cycle by rinsing the
The dishwasher must not be used without the filters. Improper replacement of the filters may reduce the performance of the appliance.
Cleaning the Spray Arms
Food particles may become encrusted on the spray arms and block the hole (see "Close up view [interior]" on page 3, letters
A
B
Troubleshooting
Resolving minor problems yourself
Experience has shown that you can resolve most problems that rise during normal daily usage yourself, without having to call out a service engineer.Not only does this save costs,but it also means that the appliance is available for use again that much sooner. The following list of common occurrences and their rem- edies should help you identify the causes of most problems.
Problems...
...when the appliance is switched on
Appliance does not start up
Fault with fuse in mains electricity supply.
Plug not inserted in wall socket.
Appliance door not closed properly.
Knob stay at the mark of "RESET"
Water tap not turned on.
Blocked strainer in water intake hose.
- The strainer is situated in the Aquastop or
Caution
Do not forget that repairs should only be carried out by a qualified specialist. Improper repairs can lead to considerable equipment damage as well as danger to the user.
...with the appliance itself
When the alarm sounds in a series of 2 beeps, pause,
2 beeps, pause ...
the water is turned on and the hose is connected properly; the water supply to the house is on and has sufficient pressure; the water supply hose is crimped or bent;
the filter for the water supply hose is clogged. the drain hose is too low.
When the alarm sounds in a series of 3 beeps, pause,
3 beeps, pause ...
the drain hose is crimped or bent.
the drain hose is too high.
When the alarm sounds in a series of 4 beeps, pause,
4 beeps, pause ...
Temperature sensor failed and call your Authorised Service Center.
When the alarm sounds in a series of 5 beeps, pause,
5 beeps, pause ...
Flood switch has been activated and call you Authorised Ser-
vice centre.
When the alarm sounds in a series of 6 beeps, pause,
6 beeps, pause ...
the drain hose is too low.
When the "END" indicator is on, at the moment, the alarm sounds in a series of 7 beeps, pause, 7 beeps, pause ...
the door is not properly closed.
If you take all these checks and the dishwasher still does not function or your dishwasher have any other error display, you can power the dishwasher OFF, and wait a few minutes. You can power the dishwasher on, try it again, if the dishwasher still does not function and/or the problem persists, contact the nearest authorised service center and provide them with the following information:
the nature of the problem.
the model type number (Mod...) And the serial number (S/ N...), which are indicated on the plate located on the side of the inner part of the door.
Lower spray arm rotates with difficulty
Spray arm is blocked by small items or food remains.
.8.