Haier DW12-CFE S manual Wash Cycle Table Energy Saving Tips, How to keep Your Dishwasher in Shape

Wash Cycle Table

Energy Saving Tips

Cycle	Cycle		Description of Cycle	Detergent	Rinse Aid
	Selection
	Information
	Very dirty	dishes,	Pre-wash with hot water.
			￿

-It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the soak cycle.

-Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are.

-Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater nega- tive impact on the environment.

-There is no advantage in rinsing dishes, cookware and utensils before placing them in the dishwasher.

	pots and pans. (Not	Extended wash at 70	K
		Rinses with cold water.	30g	￿
	to be used with deli-
		Rinse with hot waterK
Heavy Duty	cate items)
		Drying.
		Prewash use cold water.
	Normal dirty dishes,	Extended wash at 55￿.		￿
	pots and pans. Stan-	Rinse with cold water.	30g
Normal Wash	dard daily cycle.	Rinse with hot water.
		Drying.
		Pre-wash with cold water.
	Normal dirty dishes,	Extended wash at 50￿K		￿ERF
	pots and pans without	Rinse with cold water.	5g+25g
Light Wash	dried on residue.	Rinse with hot waterK
(IEC-EN50242)		Drying.
	Economic, fast cycle to	Wash at 60￿.
	be used for items which

How to keep Your Dishwasher in Shape

After Every Wash

After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside.

Remove the plug

Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks.

No solvents or Abrasive Cleaning Products

To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products. Rather, use only a cloth and warm soapy water.

To remove spots or stains from the surface of the interior, use a cloth dampened with water and a little while vinegar, or cleaning product made specifically for dishwashers.

When You Go on Holiday

When you go on holiday, it is recommended that you run a wash cycle with the dishwasher empty and then remove the plug from the socket, turn off the water supply and leave the door of the appliance slightly ajar. This will help the seals last longer and prevent odors from forming within the appliance.

Moving the Appliance

If the appliance must be moved, try to keep it in a vertical position. If absolutely necessary, it can be positioned on its back.

Seals

One of the factors that cause odors to form in the dishwasher is food that remains trapped in the seals. Periodic cleaning with a damp sponge will prevent this from occurring.

	are sensitive to higher.	Rinse with warm water.	15g	￿
		Hot rinse.
Glassware	Run immediately after
		Drying.
	dishes are used.
	Economic, fast cycle to
	be used to on not very	Short wash at 40￿.	15g
	dirty dishes right after
		Cold rinse.
Rapid Wash	they are used. No dry-
	ing cycle.
	Pre-wash of dishes,
	pots and pans while	Short cold wash to prevent
	waiting for the load to	food residue from drying on
Soak	be completed after the	the dishes K
	subsequent meal.
	The cycle of heat wash-	Heat washing.		￿
	ing and dry tableware.
Heat wash

Cleaning and Special Maintenance

Filter Assembly

For best performance and results, the filter assembly must be cleaned.

The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the "A" semi-circular filter and cup under running water. To remove the filter assembly, pull on the cup handle in an upward direction. The entire filter assembly (made up of the "A" semicircular filter and the "B" fine filter) should be cleaned at least once a month. To clean the filter and the fine filter, use a cleaning brush. Then, reassemble the filter parts as shown in the figures below and inset the entire assembly in the dishwasher, positioning in its seat and pressing downward.

The dishwasher must never be used without the filters. Improper replacement of the filters may reduce performance of the appli- ance and damage dishes and utensils.

Cleaning the Spray Arms

It may happen that food particles become encrusted on the sprayer arms and block the hole (see "Close up view [interior]" , letters D-F ). Check the sprayer arms periodically and clean them when needed.

A

B

Cleaning the Water Inlet Filter

Periodically clean the water inlet filter located on the outlet of the water supply tap.

After turning off the water tap, unscrew the end of the water sup- ply hose, remove the filter and clean it carefully under running water. Then, return the filter to its place and tighten the water supply hose back into position.

.7.

GB

GB

.8.