Henny Penny CMC/CMR-105 manual Operation, Operating Controls Refer to figure Description Function

Henny Penny Model CMC/CMR-103,104,105,106,107

SECTION 3. OPERATION

3-1. INTRODUCTIONThis section provides explanations of all controls, along with operating procedures and daily maintenance. Read the Introduction, Installation and Opeation Sections before operating the unit.

Wait at least 4 hours before plugging the unit into an electrical supply. The gases and oils in the refrigeration system needs to settle before operating the compressor, or damage to the compressor could result.

3-2. OPERATING CONTROLS Refer to figure 3-1.

Fig.	Item	Description			Function
No.	No.
3-1	1	Power Switch	Turns electrical power off and on to the unit; located on the
			bottom of the control panel
3-1	2	DigitalDisplay	Shows the temperatures and the information in the Technical
			Mode
3-1	3		Used to increase setpoint values, as well as programming
			values; also, automatic defrost cycles are programmed in
			the controls, but to manually start a defrost cycle, press and
			hold	for 3 seconds to start a manual defrost cycle;
			“DEF/SET’ shows in display
3-1	4		Used to decrease setpoint values, as well as programming
			values
3-1	5		Press to view the setpoint temperature, or hold it for it for 4
			seconds to enter the program mode; once in the Program
			Mode, press		to view other parameter setpoints;
			Press		, along with	and	to change the
			parameters

3-1 303