MobileHub™ Link Operation (Optional)
| BAND/ |
|
| SEARCH |
:/J | TEL. | TITLE | 8 |
•An outgoing call from a portable telephone is also possible. However, you cannot perform different operations at the same time from a portable telephone and
•With a junction box connected outgoing, incoming, and sending history will also be recorded in the portable telephone.
•While telephoning, defeat is set to ON. When the call has finished, the unit returns to your previous setting.
•The telephone volume can be adjusted on the
•While telephoning or receiving incoming calls, press TITLE to show the Network Operator display for 5 seconds.
Incoming Calls
|
| 1 | Press :/J to receive an incoming call. | |
g MENU f Rotary 9 F | Preset buttons | 2 | Press BAND/TEL. to finish a call. | |
| Telephone mode will end and return to the original source | |||
encoder | (1 through 6) |
| ||
| mode. | |||
|
|
| ||
About MobileHub™ Link |
| • When the Automatic Calling mode is on, you can talk after 3 | ||
|
| seconds of receiving the incoming call. (See “Setting the Automatic | ||
Connect a separately sold junction box and a portable telephone |
| Calling” described below.) | ||
|
| |||
(available from Nokia) to control the incoming and outgoing calls of | Setting the Automatic Calling | |||
the portable telephone. |
| |||
Caution |
| The incoming call can be switched to Automatic Calling or Manual | ||
Even with | ||||
Calling. | ||||
telephone operation or receiving a call. For the sake of safety, | ||||
1 |
| |||
drivers are requested to refrain from operating the telephone while | Press MENU to select the SETUP mode. | |||
driving. |
| 2 |
| |
For the sake of safety, only incoming calls and | Select “TELEPHONE” by pressing gor f. | |||
outgoing calls can be operated. |
| |||
| 3 |
| ||
• If a portable telephone is connected, its address book, incoming | Turn the Rotary encoder to change to AUTO or | |||
and outgoing history are downloaded to the junction box. |
| MANUAL. | ||
• Please refer to the instruction manual of the junction box. | 4 |
| ||
|
| Press MENU to select RETURN. | ||
Telephone Mode ON/OFF |
|
| The unit returns to normal mode. | |
|
| Pressing and holding MENU for at least 2 seconds will |
return to normal mode.
Press and hold BAND/TEL. for at least 2 seconds to turn on the Telephone mode.
To turn off, press BAND/TEL.
See relevant pages for each item.
•Press BAND/TEL. during an incoming call to disconnect it.
•The initial setting of the factory is MANUAL.
•“NO PHONE” is displayed for about 2 seconds, if a portable telephone is not connected, before entering the telephone mode. Then the mode returns to the original source mode.
•When the portable telephone is taken off the junction box during an incoming or outgoing call, or during a
•When there is an incoming call while the power of
•Even if the power of the portable telephone is off, when
•Even if the ACC power of the vehicle is turned off (even if the engine is stopped) during a
•If there is an incoming call during operation (except an outgoing call or talking), operation mode will end and switch to the incoming or talking mode.