1Amplifier Link Connector
Outputs Amplifier Link control signals. Connect this to a separately sold Amplifier
2Antenna Receptacle
3Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if applicable.
This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier, or a signal processor, etc.
4Remote
Connect this lead to the remote
5Audio Interrupt In Lead (Pink/Black)
6Illumination Lead (Orange)
This lead may be connected to the vehicle's instrument cluster illumination lead. This will allow the backlighting of the unit to dim whenever the vehicle's lights are turned on.
7Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+)12V only when the ignition is turned on or in the accessory position.
8Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's battery.
9Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.
!Choke Coil with Fuse Holder (15A)
"Power Supply Connector
#Right Front (+) Speaker Output Lead (Gray)
$ Right Front
%Right Rear
&Right Rear (+) Speaker Output Lead (Violet)
( Left Rear (+) Speaker Output Lead (Green)
) Left Rear
~Left Front
+Left Front (+) Speaker Output Lead (White)
,
Connect this to the output or input connector of another device (CD Changer, Equalizer, etc.) equipped with
You can input TV/video sound by connecting an optional Ai- NET/RCA Interface cable
-
. Front Output RCA Connectors
RED is right and WHITE is left.
/Rear Output RCA Connectors
RED is right and WHITE is left.
:Subwoofer RCA Connectors
RED is right and WHITE is left.
;RCA Extension Cable (sold separately)
<Setting the 3WAY/2 WAY switch
Set the 3way/2way switch according to your audio system.
=System Switch
When connecting a processor or divider using
Be sure to turn the power off to the unit before changing the switch position.
>DC/DC Converter
•Do not install the converter at a location subjected to water such as under the floor mat or air conditioner. This may cause a malfunction.
•Do not bundle the DC/DC converter cable with other audio cables. Doing so may induce noise into your system.
•Keep the DC/DC converter away from the Antenna cables and the rear side of the unit, otherwise noise may be generated when receiving radio broadcast.
