Display Tilt Adjustment
Movable display
The movable display may be adjusted to 3 different tilt angles depending upon user preference.
Switching the Display modes (CDA-9835 only)
You can select the display pattern mode from three display patterns.
Press DISP/B.OUT to select the desired display pattern mode.
Each press changes the display patterns.
Basic display of each source → Animation display pattern1 → Animation display pattern2 → Basic display of each source
Press TILT 98 to adjust the tilt angle of the movable display.
•The display will close a half minute after the ignition key is turned to the OFF position.
•The adjusted tilt angle of the display is stored in memory. There is no need to
Caution
Keep hands (or any other object) away from the display while it is opening or closing to avoid damage or injury. The back of the movable display will get very warm under normal operating conditions. This is not a malfunction. Do not touch.
Adjusting Volume
Turn the Rotary encoder until the desired sound is obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its previous level.
Changing the Display Type (CDA-9833 only)
There are three selectable display types. You can also deactivate the display.
Press DISP/B.OUT to switch the display type.
TYPE1 → TYPE2 → TYPE3 → OFF → TYPE1
TYPE1 : The indicator on the left changes in a fixed sequence.
TYPE2 : The indicator on the left changes according to the setting (see "Setting the Multicolor Illumination" on page 23).
TYPE3 : The indicator on the left changes according to audio level.
Detaching and Attaching the Front Panel
Detaching
1 Turn off the unit power.
2 Press 
(Release) at the upper left side until the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel.) This is not a malfunction.
•To protect the front panel, place it in the supplied carrying case.
Attaching
1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
2 |
1 |
•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
•Attach the front panel carefully. Hold the panel by its sides to avoid pushing any buttons by mistake.
