Hoshizaki DCM-500BWH-OS service manual

Page 69

2.On water-cooled model only, remove the water from the water-cooled condenser:

1)Make sure the control switch and the power switch are in the "OFF" position and that the power supply is off. Remove the top, apron, and left side panels.

2)Close the condenser water supply line shut-off valve and open the condenser water supply line drain valve.

3)Attach a compressed air or carbon dioxide supply to the condenser water supply line drain valve.

4)Open the water regulating valve by using a screwdriver to pry up on the spring retainer underneath the spring. While holding the valve open, blow out the condenser using the compressed air or carbon dioxide supply until water stops coming out.

5)Close the condenser water supply line drain valve.

6)Replace the panels in their correct positions.

69

Page 68 Page 69
Image 69
Page 68 Page 69
Contents DCM-500BAH DCM-500BAH-OS DCM-500BWH DCM-500BWH-OS Hoshizaki AMERICA, INC Contents Page DCM-500BAH Specifications IcemakerWater TEMP. F DCM-500BAH-OSWater TEMP. F DCM-500BWHPotable Water Water Cooled Condenser DCM-500BWH-OSII. General Information Construction DCM-500BWH-OS DCM-500BAH-OS, DCM-500BWH-OS Ice Making UnitSequence of Operation Startup Control Board Control Board Control Board Layout DCM-500BAH, DCM-500BWHPart Number 2A2649-01 LED Lights FeaturesControl Board Check Procedure Controls and Adjustments Portion ControlPower Supply Ice Making ComponentsDispensing Components DCM-500BAH, DCM-500BWH Float Switch DCM-500BAH-OS DCM-500BWH-OS Wire Color Code Wiring DiagramsDCM-500BAH-OS, DCM-500BWH-OS DCM-500BWH-OS Sequence of Electrical Circuit Ice MakingIce Purge Cycle Freeze Cycle Hour Drain Cycle / Drain Switch Shutdown Low Water Safety High Pressure Switch Continuous Dispense Sequence of Electrical Circuit DispensingPortion Dispense ICE Production Performance DataTotal IV. Service Diagnosis Diagnostic Procedure Ice Production Check No Ice Production Diagnostic ChartsProblem Possible Cause Remedy Problem Possible Cause Remedy Low Ice Production Other Dispensing Opti Serve OS Sensors 5a. Ice Dispensing Continuous Mode 5b. Ice Dispensing Portion Mode5c. Water Dispensing Service for Refrigerant Lines Removal and Replacement of ComponentsRefrigerant Recovery BrazingEvacuation and Recharge R-404A Removal and Replacement of Compressor Removal and Replacement of Expansion Valve Removal and Replacement of Evaporator Assembly Components Upper Bearing Wear Check Removal and Replacement of Extruding HeadRemoval and Replacement of Evaporator Removal and Replacement of AugerPage 5b. Lower Housing Removal and Replacement of Gear Motor Page Removal and Replacement of Water-Cooled Condenser Page Removal and Replacement of Fan Motor Adjustment of Water Regulating Valve Water-Cooled Model OnlyRemoval and Replacement of Drain Valve Removal and Replacement of Inlet or Dispensing Water ValveRemoval and Replacement of Dispensing System Dispensing Auger and AgitatorDispensing or Agitating Motor Page Cleaning and Sanitizing Instructions VI. Cleaning and MaintenanceWater System Cleaning SolutionDispensing Components Sanitizing SolutionBin Control Bracket Snap Pin Frequency Area Task MaintenancePreparing the Icemaker for Long Storage
Related manuals
Manual 69 pages 4.5 Kb

DCM-500BWH-OS specifications

The Hoshizaki DCM-500BWH-OS, DCM-500BWH, DCM-500BAH, and DCM-500BAH-OS are advanced ice makers designed to meet the needs of busy commercial environments. Hoshizaki is a renowned manufacturer known for producing high-quality refrigeration and foodservice equipment, and their DCM series of ice makers exemplifies this commitment to excellence.

One of the main features of the DCM-500 series is its ability to produce a significant amount of ice, ideally suited for restaurants, bars, and hotels. With a production capacity of up to 500 pounds of nugget ice per day, these units provide an efficient solution for establishments that require a steady supply of ice.

The nugget ice produced by the DCM-500 series is not only soft and chewable but also retains the cold temperature longer, making it perfect for beverages. This appealing characteristic of nugget ice caters to growing customer preferences for premium ice options.

These models also incorporate advanced ice-making technology, ensuring consistent quality. The DCM-500BWH-OS and DCM-500BAH-OS variants feature a self-contained design that makes installation simple and efficient, providing enhanced portability that makes them versatile for different locations within a commercial space.

The DCM-500BWH and DCM-500BAH models are equipped with features like a built-in ice bin that allows for storage convenience. The ice bins have a substantial holding capacity, reducing the frequency of refills and improving overall operation efficiency.

Additionally, the DCM-500 series is designed with energy efficiency in mind. Integrated with modern refrigeration systems, these ice makers comply with energy-saving standards, helping to reduce operational costs. User-friendly controls allow for easy adjustment and monitoring, ensuring that operators can manage their ice production without hassle.

Moreover, the robust construction materials used in these models increase durability, making them suitable for high-demand environments. Features such as easy-to-clean surfaces and self-diagnostic systems further optimize maintenance, ensuring prolonged performance without significant downtime.

Overall, the Hoshizaki DCM-500BWH-OS, DCM-500BWH, DCM-500BAH, and DCM-500BAH-OS ice makers are excellent choices for businesses seeking reliable and high-capacity ice production. Their advanced features, energy efficiency, and user-friendly operation make them a valuable addition to any commercial kitchen or bar setup.
Top Page Image Contents