Installation

Installing the V-Lock™Assembly Kit

If your speakers are not already installed, follow the instructions outlined in the SI 3 User's Guide supplied with the speakers (or online at www.extron.com).

If your speakers are already installed, replace the V-Lock assembly by following the instructions, below.

NReferring to packaging information for location, carefully remove and check contents before installation.

NExtron recommends that the wiring installation is performed by a professional audio equipment installer.

NFor speaker details, specifications, troubleshooting tips, and service access information, refer to the

SI 3 User's Guide supplied with the speakers, or online at www.extron.com.

Existing wall mounting application

To replace a damaged V-Lock assembly that is already installed, do the following:

1.	Remove the Extron logo from the front of the speaker to
	access the hex cap screw. Retain the logo.
2.	Insert the hex tool and unlock the speaker.
3.	Carefully lift the speakers away from the bracket, then
	disconnect the seismic cable and audio wires from the rear
	of the speakers.

Negative	INPUT
Negative
Wire	Positive Wire

To remove (or insert) the wires, push down on the spring terminals at the back of the speaker. Release the springs to secure.

Figure 3 — Remove audio wires from the terminals

NIf the ends of the wires are damaged and need to be re-stripped, follow the instructions in the SI 3 User's Guide.

V-Lock™Wall Mount Assembly Kit • Installation