Extron electronic V-LockTM manual Installation, contd, Insert the speaker wires see figure

Installation, cont'd

4. Rotate the stage (V-lock groove) 90 degrees to the wall plate (see figure 4), to access the screws in the wall plate.

Rotate this

section 90°...

	...and remove
	screws.
Figure 4 — Remove the old V-Lock Assembly
5.	Carefully remove and retain the mounting screws, taking
	care not to damage the mounting holes in the wall.
	Remove the mount from the wall.
6.	Remove a new V-Lock assembly from its box, loosen the
	hex cap screw and rotate the front section approximately
	90 degrees to the mounting plate (see figure 4). Lightly
	tighten the hex cap screw to temporarily lock it in position,
	allowing access to the mounting holes in the wall plate.
7.	Pass the wire through the access hole in the wall plate and
	using the existing mounting holes and screws, securely
	mount the new assembly wall plate to the wall.

NIf the mounting holes in the wall are damaged and unusable, or a new location is desired, create new mounting holes, following the instructions in the SI 3 User's Manual.

8.	Loosen the hex cap screw and turn the stage back to its
	upright position. Retighten the hex cap screw to lock it in
	place.
9.	Reattach the seismic cable to the speaker (see figure 5).
	Insert the speaker wires (see figure 3).

Anchor this end to a suitable secure point.

Seismic Safety Cable

Attach cable here and secure it.

Figure 5 — Re-attach the seismic safety cable

3V-Lock™Wall Mount Assembly Kit • Installation