Installation, cont’d
Under-furniture mounting
The GLI 350xi or ADA 2/GLI 350xi can be mounted under furniture, such as a desk or table, using the optional MBU 125 mounting kit (Extron part
1. | If rubber feet were previously installed on the bottom of |
| the unit, remove them. |
2. | Attach the mounting brackets to the GLI with the provided |
| machine screws. |
Under-furniture mounting of the GLI
3. | Hold the unit with the brackets attached against the |
| underside of the table or other furniture. Mark the location |
| of the screw holes of the bracket on the mounting surface. |
4. | Drill four pilot holes, each 3/32" (2 mm) in diameter by |
| 1/4" deep (6.3 mm) in the mounting surface at the marked |
| screw locations. |
5. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until just less than |
| 1/4" (6.3 mm) of the screw head protrudes. |
6. | Align the mounting screws with the slots in the brackets |
| and place the unit against the surface, with the screws |
| through the bracket slots. |
7. | Slide the unit slightly forward or back, then tighten all four |
| screws to secure the unit in place. |
GLI 350xi & ADA 2/GLI 350xi
Chapter3Three
Operation
Front Panel Features and Operation
Rear Panel Features and Operation