Extron electronic ADA 2/GLI 350xi user manual Installation, Application Example, Tabletop use

Installation

Application Example

The following illustration is an application example for the GLI 350xi.

Extron

GLI 350xi

Ground Loop

Isolator

Projector

GLI
350	xiS
GROUNDLO
OP ISOERIES
	LATOR

Mounting the GLI 350xi and ADA 2/GLI 350xi

The GLI 350xi and ADA 2/GLI 350xi ground loop isolators can be set on a table, mounted on a rack shelf, or mounted under a desk or other furniture.

NInstall the GLI near the display device(s) rather than near the source device. See the previous application example illustration.

Tabletop use

Four self-adhesive rubber feet are included with the ground loop isolator.

For tabletop use, attach one foot at each corner of the bottom side of the unit and place the unit in the desired location.

Extron

RGB 109xi

Interface

Front	INPUT
	MBUOF	RE
	NFEITORDLO
		OUTCPAULT

H.

SHIFT

VGAIN	RGB1
TER
FACE W		09xi
		/ADSP

Rear

SPARE

SERR

DDSP

SOGOUT

UL rack mounting requirements

The following Underwriters Laboratories (UL) requirements pertain to the safe installation of the equipment in a rack.

1.	Elevated operating ambient temperature — If the unit
	is installed in a closed or multi-unit rack assembly, the
	operating ambient temperature of the rack environment
	may be greater than room ambient temperature.
	Therefore, install the equipment in an environment
	compatible with the maximum ambient temperature
	(Tma = +104 °F, +40 °C) specified by Extron.

Local Monitor

PC

GLI 350xi application example

2.	Reduced air flow — Install the equipment in a rack so that
	the amount of air flow required for safe operation of the
	equipment is not compromised.
3.	Mechanical loading — Mount the equipment in the rack so
	that a hazardous condition is not achieved due to uneven
	mechanical loading.
4.	Circuit overloading — Connect the equipment to
	the supply circuit and consider the effect that circuit
	overloading might have on overcurrent protection and
	supply wiring. Appropriate consideration of equipment
	nameplate ratings should be used when addressing this
	concern.
5.	Reliable earthing (grounding) — Maintain reliable
	grounding of rack-mounted equipment. Pay particular

attention to supply connections other than direct connections to the branch circuit (e.g., use of power strips).

2-2 GLI 350xi & ADA 2/GLI 350xi • Installation GLI 350xi & ADA 2/GLI 350xi • Installation 2-3