Grindmaster MG236-2B Model G23-2B Electronic Touchpad, Setting Defrost Timer Night Setting

Model G23-2B Electronic Touchpad (cont.):

Auger ON/OFF Button:

1.) Turns auger ON and OFF when main power switch is ON.

2.) Must be ON to permit defrost time to be reset.

3.) Must be ON to activate the “Mode/Press To Select Function” button to select manual “OFF”, “FREEZE” or “COOLING” functions.

Mode/Press To Select Function Button:

1.) Used to manually select “OFF”, FREEZE” or “COOLING” functions when auger is turned ON.

2.) Accesses defrost timer reset mode when depressed for an extended period when auger is turned ON.

3.) Locks in hours, minutes and final time settings after they are reset using the “Auto Timer” button.

4.) Does not function when light on “Auto Timer” button is illuminated.

“Auto Timer” button

1.) Turns auto defrost mode ON or OFF (light on switch indicates when auto defrost mode is activated).

2.) Used to adjust the hours and minutes settings when readjusting current time or auto defrost timer.

Enter Time Programming on Initial Installation or in the Event of a Time Change:

1.) Turn OFF power switch.

2.) While pressing left “Press To Select Function” button, turn ON power switch while continuing to hold the “Press To Select Function” button until the display illuminates (hour digits will start to blink).

3.) First set hour by pressing the “Auto Timer” clock button until the appropriate hour is shown (note: when using a 12 hour clock the time is P.M. when the dot at the bottom right corner of the LED is lit; when dot is not lit it is A.M.)

4.) To set the minutes press the left “Press To Select Function” button, then press the “Auto Timer” clock button until the appropriate minutes are set.

5.) To save your settings press the “Press To Select Function” button one more time.

Setting Defrost Timer (Night Setting):

1.) Turn power switch ON.

2.) Then press “Auger ON/OFF” button on for the side you are setting.

3.) Then press and hold the “Press To Select Function” button until you hear a long beep and the LED, “cold” and the “Auto Timer” clock light begins to blink.

4.) Press the “Auto Timer” clock button to set the hour you want it to turn to refrigeration mode and then press the “Press To Select Function” button to save the setting.

G & MG Series Granita Machine Page 5