Light bulb replacement
Care and Cleaning
Icemaker
The icemaker has a light bulb in the top of the 5. Plug in the icemaker or reconnect power. storage bin. To replace it, open the bin door
and follow these instructions:
1.Unplug the icemaker or disconnect power.
2.Remove the 3 screws that hold the cutter grid cover in place. Reach behind the control panel and pull the light bulb down.
3.Replace with a
4.Replace the cutter grid cover with the 3 screws.
Vacation and moving
To shut down the icemaker:
1.Unplug the icemaker or disconnect power.
2.Remove all ice from the storage bin.
3.Shut off the water supply.
4.Remove the 2 screws in the lower access panel and the 2 screws from the base grille area of the front panel support. Pull forward to remove the lower access panel.
5.Disconnect the inlet and outlet lines to water valve. Allow these lines to drain and then reconnect to the valve.
6.Replace the lower access panel and screws. Drain water from water reservoir by removing the drain cap. Also, remove water from drain line. Leave the door open
to allow the icemaker and water reservoir to dry out completely.
7.Before using again, clean the icemaker and storage bin.
IMPORTANT: Every time the icemaker is turned off, you MUST clean the icemaker system with the Nickel Safe Ice Machine Cleaner. See Care and
8.Plug in the icemaker or reconnect power.
NOTE: All components of the icemaker are permanently lubricated at the factory. They should not require any additional oiling throughout the normal life of the machine.
Reverse Osmosis system
IMPORTANT: The performance of the icemaker may be affected when connected to a Reverse Osmosis system. An RO system may also reduce water pressure and affect the fill cycle, which is dependent on time and flow. The reduced water pressure (less than 20 psi) may cause the reservoir not to fill and flush properly during the ice making cycle.
Do not use copper tubing when the icemaker is connected to a Reverse Osmosis water system.
13