GE Monogram ZDIS15, ZDI15 owner manual Remove packaging, Clean before using Set controls

Page 8

Controls and Features

Icemaker

Remove packaging

IMPORTANT: Do not remove any permanent instruction labels inside your icemaker or the Tech Sheet that is fastened behind the lower access panel.

•Remove tape and any labels from your icemaker before using (except the model and serial number label).

To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

•Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners to remove tape or glue. These products can damage the surface of your icemaker. For more information, see Important Safety Instructions.

Clean before using

Set controls

After you remove all of the packaging

See the cleaning instructions in Care and

materials, clean the inside of your icemaker

Cleaning.

before using it.

 

1.

To start the normal ice making cycle,

NOTE: The CLEAN setting is used whenever

 

select ON.

solutions are circulated through the icemaker

2.

To stop icemaker operation, select OFF.

for cleaning. See Care and Cleaning.

 

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents ZDI15 ZDIS15 Contents Before using your icemakerIntroduction Write down the model & serial numbersIf you need service If you received a damaged icemakerRead and Save These Instructions Lire ET Conserver CES Instructions AvertissementHOW to Connect Electricity Raccordement ÉlectriqueExtension Cords RallongesRefrigerants RéfrigérantsClean before using Set controls Remove packagingFeatures of your icemaker How your icemaker works Making IceCaring for your icemaker Exterior surfacesIcemaker system CondenserReverse Osmosis system Light bulb replacementVacation and moving Problem Solver Questions?GE Answer Center Your Monogram Icemaker Warranty From the Date Original Purchase
Top Page Image Contents