GE Monogram ZDIB50 Cleaning the Inside Parts of the Icemaker, Remove the hose from the water pump

Page 9

Cleaning the Inside Parts of the Icemaker

WARNING:

• Do not operate the icemaker with the lower access panel or control panel

removed. Electrical shock or personal injury could result.

•Do not wash plastic parts in dishwasher. They cannot withstand temperatures above 145°F. (63°C.).

1.Turn the Cycle Control Knob to “OFF” and disconnect the electrical power supply to the machine. Open the storage bin door and remove any ice that is in the bin.

ICE

CYCLE

Ice Retainer Baffle

2.Remove the ice retainer baffle by flexing it and then slide it off the studs.

3.Remove the ice cutter grid by unscrewing the two screws, sliding the grid forward and unplugging the electrical wire harness.

Screws

 

 

Drain

 

Plug

Water Pan

Insert into

drain

 

4.Remove the water pan by unscrewing and removing the two screws and washers.

Hose

Water

Pump

Water Distributor

6.Remove the water distributor from the freezing plate. It is held in place by rubber end caps. Remove the inlet hose and clean all water distributor holes and the small orifice in the inlet side of the distributor. When replacing the distributor, make sure the end caps are located in the evaporator flange detents and that the water distributor holes face down.

7.Wash the interior components (ice retainer baffle, cutter grid, water pan, inlet hose and water distributor) and the storage bin, door gasket and ice scoop with mild soap or detergent and warm water. Rinse in clean water. These components should also be cleaned in a solution of one tablespoon (15 ml) of household bleach in one gallon (3.8 L) warm water. Rinse again thoroughly in clean water.

8.Replace the interior components: water distributor, inlet hose and water pan.

9.Check the following:

•The hose from the water valve is in the water pan.

•The rubber drain plug is in the water pan.

•The water distributor is seated and the holes are facing down.

•The hose is reconnected to the pump and the water distributor.

•The hose from the water pan is inserted into the storage bin drain opening.

10.Reconnect the electrical harness, slide the cutter grid into place and tighten the screws. Replace the ice retainer baffle.

11.Turn Cycle Control Knob to “ON.”

(continued next page)

5. Remove the hose from the water pump.

9

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Monogram.TM Introduction ContentsHelp US Help YOU… If YOU Need ServiceRead All Instructions Before Using This Appliance Important Safety InstructionsHow the Icemaker Works Operating Your IcemakerSetting the Controls Features of Your IcemakerCleaning Outside Surfaces Care and CleaningCleaning the Condenser Dirty or clogged condenserTurn the Cycle Control Knob to OFF Cleaning the Icemaker SystemRemove the hose from the water pump Cleaning the Inside Parts of the IcemakerChanging the Light Bulb Filtering and Treating WaterUnpacking the Icemaker PreparationLocation LevelingDoor and Access Panels Changing the Bin Door PanelTo change the panel Changing the Lower Access Panel Custom Door and Access Panels-1/4″Thick Custom Door and Access PanelsCustom Door and Access Panels-3/4″Thick Install Custom Door and Access PanelsTo shut down the icemaker Vacation and MovingInstallation Requirements Free Standing InstallationFor the Installer Recommended Grounding MethodsDrain pump specifications Each installation is unique but will requireAn electrical branch circuit of 115 volt, 60 Hz Connect to water. Observe local codesDrain Pump Installation InstructionsQUESTIONS? USE this Problem Solver We’ll Be There Warranty Page Máquina para hacer hielo Contenido IntroducciónSI SE Necesita Servicio Ayudenos a AYUDARLE…Instrucciones DE Seguridad Cómo funciona la máquina para hacer hielo Operacion DE SU Maquina Para Hacer HieloCaracteristicas DE SU Maquina Para Hacer Hielo Ajustando los controlesPase Limpieza de las superficies exteriores Cuidado Y LimpiezaLimpieza del condensador Un condensador sucio o tapadoLimpieza del sistema de la máquina para hacer hielo Caliente del grifo En la bandeja paraAgua* y haga girar La perilla de Control De ciclo hasta la Limpieza de los componentes interiores Cambio de la bombilla Filtrado y tratamiento del aguaLocalización PreparacionNivelación Calibraciones del termostatoPara cambiar el panel Puerta Y Paneles DE AccessoPuede sufrir un choque eléctrico o lesiones personales Cómo cambiar el panel inferior de accesoPuerta Y Paneles DE Acceso a LA Medida Puerta y paneles de acceso a la medida de 1/4″ de espesorPuerta y paneles de acceso a la medida de 3/4″ de espersor Vacaciones y mudanzas Instrucciones Para LA Instalacion Instalacion IndependientePara el instalador Métodos que se recomiendan para conectar a tierra237/8″ Cada instalación es individual pero requeriráContinuación Nivelacion¿ALGUNA PREGUNTA? Consulte Estas Soluciones Estaremos Con Usted Garantia Notas

ZDIB50 specifications

The GE Monogram ZDIB50 is a standout built-in refrigerator that offers a fusion of sophisticated design and advanced technology, appealing to culinary enthusiasts and design aficionados alike. With a total capacity of 20.7 cubic feet, this refrigerator provides ample storage space for groceries, beverages, and other essentials, making it a perfect fit for any modern kitchen.

One of the standout features of the ZDIB50 is its dual-compressor system, which allows for independent temperature control of the refrigerator and freezer compartments. This technology not only maintains optimal temperatures but also ensures food preservation by minimizing temperature fluctuations. The refrigerator’s advanced climate control system includes humidity-controlled crispers, which help keep fruits and vegetables fresh for longer periods, enhancing the overall longevity of your food items.

The design of the GE Monogram ZDIB50 is as impressive as its features. Its sleek stainless steel exterior, complemented by integrated handles, adds a touch of elegance to any kitchen. The unit also comes with a customizable panel option, allowing homeowners to match it with their cabinetry for a seamless look. Inside, the refrigerator features glass shelves that are adjustable and spill-proof, making clean-up and organization a breeze. The bright LED lighting illuminates the interior, showcasing the contents and making it easier to find what you need.

In terms of energy efficiency, the ZDIB50 boasts significant energy savings, being ENERGY STAR certified. This certification not only benefits the environment but also helps reduce utility costs for homeowners. The refrigerator is equipped with smart features that allow users to monitor and manage its performance remotely through a smartphone app, giving added convenience to busy lifestyles.

The ice maker is another highlight of the GE Monogram ZDIB50, producing a plentiful supply of crescent-shaped ice, which is perfect for entertaining guests or enjoying refreshing beverages. The water filtration system ensures that the ice is made from clean and purified water, enhancing safety and flavor.

In conclusion, the GE Monogram ZDIB50 combines cutting-edge technology, excellent efficiency, and sophisticated design into one remarkable appliance. It reflects the perfect balance of style and functionality, catering to those who demand the best in their kitchen. Whether you are a casual cook or a gourmet chef, this refrigerator is sure to enhance your culinary experience.
Top Page Image Contents