GE Monogram ZGU48L6D, ZGU36N6, ZGU36N4D, ZGU36N4R, ZGU36L4R, ZGU36L4D Sealed, Burner, Assemblies

Page 21

Care and Cleaning

Stainless Steel Cooktop

Sealed

Turn all controls OFF before removing the

burner

burner parts.

The burner grates, burner caps and burner

assemblies

ring sub-assemblies can be lifted off, making

 

 

them easy to clean.

 

CAUTION: DO NOT OPERATE THE

 

BURNER WITHOUT ALL BURNER PARTS

 

IN PLACE.

Electrode

The electrode of the

 

spark ignitor is behind

 

each burner. When one

 

burner is turned to

 

“ON” to light, all the

burners spark. Do not attempt to disassemble

or clean around any burner while another burner is on. An electric shock may result,

Slits

Holes

Use a sewing needle, twist-tie and/or toothbrush to unclog the small holes and slits in the burner heads and burner rings.

To aid reassembly, each brass Burner Head is marked with a clock face. Replace the Burner Head with the arrow pointing to the rear of the cooktop (12 o’clock position).

MISE EN CAUSE : N’UTILISEZ PAS DE BRÛLEUR QUI N’A PAS TOUTES SES PIÈCES EN PLACE.

For proper ignition, make sure the small holes in the burner rings are kept open. A sewing needle or wire twist-tie works well to unclog them.

The slits in the burner heads of your cooktop must be kept clean at all times for an even, unhampered flame.

You should clean the surface burner routinely, especially after bad spillovers, which could clog these openings.

To remove burned-on food, soak the burner heads and rings in a solution of mild liquid detergent and hot water for 20–30 minutes. For more stubborn stains, use a toothbrush.

Clean the burner bases in place on the cooktop.

To remove the burner parts:

1Lift off the burner cap and burner head.

2Remove the burner ring locking nut using a 1116″ socket wrench, crescent wrench or

channel-lock pliers.

3Lift off the burner ring. Do not remove the burner bases.

Before putting the burner parts back, shake out excess water and then dry them thoroughly by setting them in a warm oven for 30 minutes.

To replace the burner parts:

Make sure all parts for the burner are firmly seated.

1Align the locator pins on the burner ring into the labeled hole in the burner base. Seat in place.

2Replace the burner ring locking nut and hand-tighten. Using the wrench or pliers, turn the nut 1/4 turn to secure it in place.

3Align the locator pin in the burner head into the hole in the burner ring. Seat in place.

4Replace the burner caps.

which could cause you to knock over hot cookware.

 

Burner Cap

 

Burner Head

 

(Brass)

Locator Pin

Burner Ring

Locking Nut

 

Burner Ring

 

(Aluminum)

Locator Pin

Electrode

 

Burner Base

Pin

 

Slot

 

NOTE: Locator pin fits into burner base pin slot.

High Output Burners

21

Image 21
Contents Stainless Steel Professional 36″ and 48″ Gas Cooktops Introduction ContentsIf you need service Before using your cooktopWrite down the model & serial numbers If you received a damaged cooktop Save time & moneyImportant Safety Notice Avis Important DE Sécurité Do not use a towel or other bulky cloth Précautions DE Sécurité Safety Precautions Vous sentez le gaz Surface Cooking Cuisson DE Surface Design information Features of Your CooktopHow to select flame size Electronic ignition & automatic reignitionTo light a burner Simmering Dual-flame burnersWok cooking CookwareGrill grates Excessive grill flare- ups and flamingGourmet Radiant Tray To season the grill grateUsing the grill Gourmet Radiant TrayDo not leave the grill unattended while it is on Before using the griddle Griddle assembly should not be removed for cleaningGrilling hints Using the griddle Seasoning the griddleTo season the griddle Control panel and knobs Stainless steelDo not use a steel-wool pad it will scratch the surface Sealed BurnerAssemblies Burner grates Burner capsDrip trays, drip tray liners and drain tubes Do not use a steel wool pad it will scratch SurfaceGriddle GrillBackguards and shelf Questions? Before you call for service… In-Home Repair Your Monogram Cooktop Warranty Registration Ownership Product Consumer Consumer Product Ownership Registration