Care and Cleaning
Professional Range Hood
Stainless steel surfaces (on some models)
Do not use a steel-wool pad; it will scratch the surface.
1.Shake bottle well.
2.Place a small amount of CERAMA BRYTE® Stainless Steel Cleaning Polish and Conditioner on a dry cloth or dry
paper towel.
3.Clean a small area (approximately 8″ x 8″), rubbing with the grain of the stainless steel if applicable.
4.Dry and buff with a clean, dry paper towel or soft cloth.
5.Repeat as necessary.
To order:
To order CERAMA BRYTE® Stainless Steel Cleaning Polish and Conditioner, please call our
National Parts Center . . . . . . . 800.626.2002
www.GEAppliances.com
CERAMA BRYTE®
Stainless Steel Cleaning
Polish and Conditioner . . . . . . . # PM10X313
Light bulbs
The bulbs are located on the underside of the hood.
To change the light bulbs:
1.Remove the trim ring by turning it counterclockwise.
2.Grasp the bulb on the edges and remove by turning it counterclockwise.
3.Replace with the same type and size bulb.
These 120 volt, 50 watt, par 16 halogen flood bulbs, with standard base, are available at specialty lighting stores.
These bulbs can also be ordered from your GE supplier.
Order bulb no. WB08X10028.
Warming lamps
The warming lamps are located on the underside of the hood.
These 120 volt, 175 watt, par 38 infrared heat lamp bulbs, with standard base, are available at some specialty lighting stores.
These infrared bulbs can also be ordered from your GE supplier.
Order bulb no. WB08X10029.
NOTE: If warming lamps are not desired, additional cooktop lighting can be obtained by replacing the infrared bulbs with standard incandescent bulbs with up to 100 watt maximum ratings, with standard bases. These bulbs are available at specialty lighting stores.
8