For RECESSED-BOTTOM Cabinets only | GE Monogram RN328, JV347, JN327

Installation Instructions

8FOR 31⁄4″ X 10″ RECTANGULAR

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Attach exhaust adaptor/damper over the appropriate knockout opening (for vertical or horizontal, depending on installation) with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back edge of hood. Remove tape from damper flap.

	Exhaust adaptor/damper
Up to 1″ side-to-	(vertical discharge position)	Tape
Up to 1″ side-to-		Tape
side adjustment

Pivot

Top/back edge

(depending on

installation)Exhaust adaptor/damper (horizontal discharge position)

NOTE: The exhaust adaptor/damper can be installed up to 1 inch on either side of the hood center to accommodate off-center ductwork. In extreme off- center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

9FOR 7″ ROUND VERTICAL

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Bend up the duct alignment ears in preparation for later attachment of the 7″ duct.

Attachment ear tabs

10FOR RECESSED-BOTTOM CABINETS ONLY

Wood shims

(minimum thickness 3/8″)

•If the cabinets have front, side or back trim, make 2 wood shims a minimum of 3/8″ thick and cut to fit the width of the inner recessed cabinet bottom. Attach them to the cabinet bottom recess on both sides. See Step 11 for marking locations.