
SLOW JUICER ASSEMBLY
Align hopper front triangle with [ ] bowl triangle [
OPEN ] first and turn it to clockwise until it clicks so that the hopper triangle [
] aligned with bowl triangle [Close
].
Make sure to press the screw down into the strainer as in STEP 2. The hopper does not close properly when the screw does not fit in completely.
Assemble the parts as following order :
Bowl > Spinning Brush > Strainer. Make sure bowl triangle [ OPEN ] aligns with strainer triangle [
].
A spinning brush can be assembled regardless of the direction.
Place the bowl in the base.
SLOW JUICER ASSEMBLY IN DETAIL
4 Align the hopper rear part with base completely as in below.
The hopper will not close properly when the parts are not assembled correctly.
| Hopper |
| rear part |
2,3 | Assemble the parts in the order of bowl > spinning brush > strainer > squeezing screw > hopper |
(or assemble the spinning brush into the bowl then fit strainer bump in the bowl inner groove). | |
Make sure all the triangles of bowl [ OPEN ], strainer [ ] and hopper [ ] are aligned in a vertical line. |
| Strainer | BOTTOM |
Hopper | bump | OF THE |
| STRAINER | |
|
| |
Squeezing Screw |
|
|
Strainer |
| INSIDE THE |
| Bowl inner | |
| groove | BOWL |
Spinning brush |
|
|
Bowl | Open |
|
|
|
1 Insert extraction packing at the bottom of the bowl hard enough into the pulp outlet. Make sure bowl outer groove aligns with base bump completely
Base bump |
Extraction |
packing |
Bowl outer groove |
8 | 9 |
|
|