Lincoln Electric IM911 manual Off, Installation

A-1		INSTALLATION	A-1
	TECHNICAL SPECIFICATIONS – COOL ARC® 40
Product No. / Model		K2187-2 (COOL ARC® 40 230V International)
		Via Continental European (SCHUKO)- PRONG PLUG
Input		220-240VAC	50/60 Hz 1 Phase
Current Draw @ 60Hz Input		1.3-1.7 Amps
Current Draw @ 50Hz Input		2.0-2.4 Amps
Maximum Operating Pressure and Flow Rate		60 psi (414 kPa) (4.14 bar)Max.
(Open Flow, Without Welding Torch Restriction)		1.66 gal/min. (6.28 liter/min) Max.
Typical Operating Pressure and Flow Rate		53-57 psi (365-393 kPa)
(With Welding Torch Restriction)		.45-.60 gal/min. (1.7-2.3 liter/min)
Reservoir Size		2.0 ga. (7.6 liters)
		For Use Above Freezing: Use Clean tap, distilled or de-ionized water.
		For Use Below Freezing: Use 50% water and 50% pure ethylene glycol
		(reagent	or industrial grade) mixture.
		DO NOT USE: Automotive anti-freeze that contains rust inhibitors or leak stoppers.
Recommended Coolant		These coolants will damage the pump and block the small internal passageways of the
		heat exchanger, affecting cooling performance. To acquire the proper coolant contact
		a local welding distributor.
		DO NOT USE: Pre-packaged welding industry coolants. These coolants may contain
		oil-based substances, which attack the plastic components of the cooler. Once added
		to the cooler, these substances are impossible to purge from the water lines and heat
		exchanger.
	Shipping	46.5 lbs. (21.1 kg)
Weight
	Reservoir	61.2 lbs. (27.8 kg)
	Full (Water)
	L	9.03 in. (229.4mm)
	W	9.10 in. (231.1mm)
Dimensions
		31.99 in. (812.6mm)
	H (Top Face)

H Top Handle)

34.26 in. (870.2mm)

EXPLANATION OF SYMBOLS THAT APPEAR ON THIS EQUIPMENT

ON

OOFF

COOL ARC® 40