Keating Of Chicago 1-800 owner manual Self-Help Guide

Self-Help Guide

PROBLEM	PROBABLE		SOLUTION
	CAUSE		(Follow Sequentially)
Motor runs but will not	Tub not set up properly.	Place components in tub per the following:
pump oil.		1.	Sump screen on the very bottom
		2. Filter paper over sump screen (Lie it flat
			on the bottom, creasing the sides).
		3. Hold down ring (ensure paper is not
			folded, lock hold down ring into place
		4.	ensuring a tight seal).
			Sprinkle Acidox powder evenly over filter
		5.	paper (1bag per 40 lbs. of oil).
			Crumb basket for large debris.
	Tub not connected to the motor	1.	Remove tub from the filter cart
	housing properly		completely by pulling the release handle
			located on the bottom of the filter control
		2.	panel.
			Place the tub onto the filter cart by first
			inserting the rear lip under the filter cart
			frame and then laying down the front of
		3.	the tub flat onto the cart.
			Connect the tub to the motor housing by
			pulling together the handles on the tub
			and the handles on the motor housing
			(NOTE: Verify tight connection by pushing
			back on the tub).
	Filter not connected inside of	1.	Ensure filter assembly is rolled straight
	cabinet	2.	onto the rails inside of the cabinet.
			Push filter assembly back as far as
		3.	possible
			Ensure quick disconnect fitting on top of
			filter connects automatically with quick
		4.	connect fitting inside of cabinet.
			Pull on filter lightly to ensure a tight
			connection
	Valve not switched to “Oil to Fryer”	1.	Set the black knob in the middle of the
		2.	filter control panel to the far right.
			Try to filter again.
	If there’s more than one fryer,	1.	Open the door of the fryer you wish to
	return valve not open.	2.	filter.
			Pull the return valve handle (small black
		3.	knob) out as far as possible.
			Attempt to filter again. When completed,
			push the black knob in as far as possible
			to close.

– 6 –