Keating Of Chicago 028951 service manual III Operating

							Clockwise movement of the knob will decrease the
ELECTRICAL							spacing; counter clockwise movement will increase the
CONNECTION							spacing. Each turn of the adjusting knob represents
Each Keating Top-Side™Cooking head is equipped							1/8'' (approximately 3mm) movement.
with a 9' (2.74m) neoprene covered, 12 gauge 4mm(2),							Experimentation will give you the best cooking height
three wire with ground electrical cord. Each cooking							for each type of food product. The cooking head should
head is rated 4000W, 18 amps, single phase at 220							contact the product firmly to ensure optimum heat
Volts and is designed to be connected to its own 208-							distribution without flattening the product.
240V single phase electrical supply. For proper
connecting and grounding procedure see local codes,
							SHUTDOWN
the National Electrical Code ANSI/NFPA 70 (latest
edition) or Canadian Electrical Code CAN C22.1 (latest							Turn ON/OFF switch to “OFF” position.
edition) as applicable.							CLEANING
	WARNING
							PROCEDURES
	THIS APPLIANCE MUST BE EARTHED.						A. Keating Cooking Sheets
III OPERATING							λ		Clean cooking sheets with a damp soft cloth after
										WARNING
									each run of product (a Turkish towel works best).
								THE COOKING HEAD WILL BE HOT. USE PROPER
	CAUTION
							CARE WHEN CLEANING THE COOKING SHEETS.
	Food will cook much faster with a Top-Side™Cooker
than with a griddle alone. Watch food while cooking or							End of day cleaning:
use timers to ensure food will not be overcooked.
							Before the griddle is turned off for the day, the cooking
	WARNING						sheets should be cleaned as described below. Wear
							heat resistant gloves for maximum safety during the
OPERATION OF THE TOP-SIDE			™	COOKER
							entire cleaning procedure.
SHOULD BE LIMITED TO PERSONNEL						1.				At the end of the day, wipe the cooking sheet in
THOROUGHLY TRAINED		IN OPERATING
PROCEDURES.										place with a damp soft cloth. Continue wiping until
										the surface of the cooking sheet is free of any
										residue.
COOKING
							2. Remove the cooking sheet from the cooking head.
1. Turn ON/OFF switch to “ON” position.
										Clean the cooking head and the griddle surfaces.
2. Press and hold the “Push to Set” button on the						3.				Wash the cooking sheet with a mild detergent in
	thermostat and adjust the knob to the desired
	temperature. The new temperature will be entered					4.				warm water and dry thoroughly.
	after 3 seconds. Red “ELEMENT ON” light will									If needed, after the cleaning is complete, reverse
	illuminate when the element is on.									the cooking sheet and reattach it to the cooking
Figure 3-1										head.
Top-SideTMCooker Control Panel							B. Cooking Sheet Clips
							To remove the stainless steel cooking sheet clips for
							cleaning, simply lift them off. They can be cleaned in a
							dishwasher.
							C.			Cooking Head
							The MIRACLEAN® surface is very durable and with
							proper care, following the procedures below, will last
							many years.
COOKING HEIGHT						1.				Scrape MIRACLEAN® surface from front to back
ADJUSTMENT										with the Keating griddle scraper with Cooking
Keating’s Top-Side™Cooker has been designed to						2.				Sheets removed.
allow you infinite height adjustments from				1/8'' to 11/2 ''						Clean and polish surface with certified Keating
(approximately 3mm to 38mm).		An adjusting knob								Klenzer on a damp soft cotton cloth. Wipe off
allows fast and precise height adjustment.										excess Klenzer.
					2