Plywood backing
The majority of the weight of the installed ventilation system will be supported by the canopy. Its mounting bracket must be firmly attached to the stud framing behind the drywall. If studs are not located in the required locations, a plywood backing (min. 1/2" (13 mm) thick) spanning at least two studs must be installed. Failure to adequately support the weight as stated may result in the ventilation system falling off the wall, causing personal injury and property damage.
(If plywood backing is not needed, proceed to "Appliance dimensions and Installation")
To install a plywood backing board
^Determine and mark the location of the retaining plate for the canopy as outlined on the Installation sheet.
^Make a cutting line 3" (76 mm) above and 3" (76 mm) below the outline of the retaining plate.
^Find the studs to the left and right of the mounting location by tapping the wall or using a stud finder.
^Mark the center of each of the studs with a vertical line.
Be careful not to damage any wiring or plumbing that may be located behind the wall. Make sure that the power supply to the area being worked in has been turned off at the breaker panel before cutting into the wall.
^Cut out the drywall along the marked
lines and replace it with plywood of a matching thickness (min. 1/2" (13 mm) thick). Tape the joints and refinish the wall.
^See enclosed installation sheet for instructions on how to install the appliance.
21