Dishwasher installation
If the adjacent cabinetry (or ap- pliance) does not have drawers and alignment to a drawer line is im- possible:
Hang the bracket on the machine door, without the templates, and tighten the four locking screws on the edges of the door panel.
Close the door.
Measure the distance from the ad- jacent cabinet (or appliance) door bottom to the bottom of the mounting bracket (X).
Using measurement (X), draw a line on the rear of the door panel (X) in- ches up from the bottom.
Remove the bracket from the ma- chine door and place it on the rear of the door panel so that:
–the bracket is centered left to right, and
–the bottom of the bracket is aligned with the (X) line.
Tape the bracket to the door panel to hold it in place while the mounting holes are being drilled.
Drill pilot holes for the screws using a 3/32" (2.5 mm) bit.
Attach the bracket to the panel using the 6 screws provided.
Remove the templates (if used).
The templates should be kept in case you want to install a different door panel on the dishwasher at a later date.
Attach the panel to the dishwasher by aligning the bracket tabs with the slots on the door.
53