Dishwasher installation
Trimming the toekick
The toekick cannot be pushed back in. It must be unscrewed, so that the tension on the spring clips can be released. The brackets can then be pushed in, and the toekick
The rear of the toekick has two cutting lines.
Screw the toekick onto the installed brackets, with the cutting lines to- wards the top, and pull out evenly until it aligns with the toekick of the adjoining cabinets.
Carefully open the dishwasher door until it hits the toekick.
Using the front lower edge of the door panel as a guide, draw a line across the toekick.
Unscrew and remove the toekick.
If one of the cutting lines is close to the line just drawn, score the front of the toekick, and snap off the excess, otherwise, trim the toekick along the line using a saw.
Screw the toekick back onto the brackets, with the cut edge at the bottom.
If the dishwasher door does not open completely, the toekick may need fur- ther trimming.
59