![](/images/new-backgrounds/1071230/7123025x1.webp)
Before using for the first time
Setting the rinse aid dosage
You can adjust the rinse aid dosage to optimize the results.
The rinse aid dosage can be set at levels between 0 and 6 ml. The factory setting is 3 ml of rinse aid. This is just a recommendation.
If the dishes are spotty:
Use a higher rinse aid setting.
If the dishes are cloudy or streaky:
Use a lower rinse aid setting.
Press the button to turn the dishwasher off.
Press and hold the Start/Stop button and simultaneously turn the dishwasher on using the button. Keep the Start/Stop button pressed for at least four seconds until the "Start/Stop" indicator light comes on.
If it does not come on, start over.
Press the Delay start button three times.
The Delay start indicator light flashes 3 times at short intervals.
The time display shows the flashing sequence p 3.
The set value is shown in the time display after the P.
Select the desired dosage with the Start/Stop button.
Every touch of the button increases the level.
The setting is saved immediately.
Press the button to turn the dishwasher off.
13